This hitch works for 1990-1993 Ford Festiva. It requires the J style tie down hooks.
Another point I forgot was when you are installing the hitch after fully welding it is to screw in the two 10mm bolts by hand all the way in then tighten with a ratchet/wrench after. This may take some time due to the tight bolt hole tolerances but just move the hitch up and down till the bolts are close to fully seated. This will help to not damage the threads.
Another point I didn't mention was when lining up the hitch receiver tube to be tacked is to make sure the holes for the receiver pin are on the sides so when you put the pin in, it will be parallel to the ground.
And lastly, double check your measurements for finding the center of the hitch for the receiver tube. If its different than mine go off of yours and find the center of that measurement.
I will be offering the mounting plates/spacers/chain hook bracket as a kit so others can build a hitch of their own at home.
Good luck and thanks for watching!!!
Негізгі бет How I built the hitch for my 1992 Ford Festiva
Пікірлер: 1