So my new motor has been nothing but problems 🥴
(AS ITS ONLY BEEN FINISHED FOR LESS THEN 24HRS!)
Fist the water pump seal was not sealing so I just went ahead and put a new water pump and put it back together. The next day after getting the engine up to temp the oil filter "bango bolt" (not sure on correct tern) decided to snap of with the aluminum piece that hold it on and that IS PART OF THE BLOCK! Bummed out and all I decided to try n fix with my "mexican enginuety" with out pulling the motor. After all, motor would have been considered junk in someone else's hands.
Now let's hope it holds up from now on since dyno will be soon if it stays together. Lol ENJOY!
Негізгі бет How I "saved" my "new" built motor from a catastrophic failure.
Пікірлер