Yep, Sounds like an old rusty wheelbarrow with ball bearings rolling around inside, maybe some exhaust cutouts would help cure that🤣🤣🤣🤣
@jessejames7140
5 ай бұрын
Sounds good
@PNW_Car_Mods
5 ай бұрын
Much appreciated sir!
@Hogiewan1
5 ай бұрын
You’re an absolute savage. I daily a 2009 and want to do the same. Let the haters give you some free fuel. That’s clean
@PNW_Car_Mods
5 ай бұрын
Thank you sir. These kinds of comments make the youtube child labor rate hobby worthwhile lol. I've got almost 5k miles or smiles on this swap already!
@bat5917
5 ай бұрын
How long have you had this the tail pipes?
@PNW_Car_Mods
5 ай бұрын
Quite a while. I think I put them on in December. I had to get them on quick as I was having to wear earplugs to drive it around with the dumps lol.
@HollywoodHornet
5 ай бұрын
My 2nd or 3rd most favorite truck on You Tube.
@PNW_Car_Mods
5 ай бұрын
hell yeah Hollywood! I'll buy that for a dollar.
@ScottLight10
5 ай бұрын
Do you think it’s possible to clear on the drivers side on a 4x4
@PNW_Car_Mods
5 ай бұрын
I can't say for certain but I am pretty sure the fuel tank is mounted exactly the same and the tank hangs so low. I should have mentioned it in the video that the fuel tank is the pain in the ass of all of this routing.
@ScottLight10
5 ай бұрын
@@PNW_Car_Mods yes and I’m planning on mounting a Bronco II tank in the rear, getting rid of the original.
@PNW_Car_Mods
5 ай бұрын
@@ScottLight10 I would think that would help a ton! I've been debating on going to a center mounted fuel cell where the spare is not so much to rearrange the exhaust but to get more range out of the truck and help with traction.
@jessejames7140
5 ай бұрын
How often are you having to tighten those headers
@PNW_Car_Mods
5 ай бұрын
As long as you use a factory GM or OEM multilayer steel manifold gasket........NEVER. They just don't come loose. If you use a crappy composite gasket, all bets are off.
@Givemethaair33
5 ай бұрын
I just want help swapping a 408 into my C6! Down in Lewis County any help is appreciated! Great Video!
@PNW_Car_Mods
5 ай бұрын
Changing engines in Corvettes is not a fun project. That is for sure!
@chrishansen7004
4 ай бұрын
Hey do you know if there’s any way to get the stock gauges working with the ls swap?
@PNW_Car_Mods
4 ай бұрын
I don't at this time. I will contact Dakota Digital pretty soon and see if they have a conversion box that will make it all work.
@colemcmeans7809
5 ай бұрын
looks good, sounds good but you didnt leave much room for the turbos.
Пікірлер: 22