I will never figure out why people paint over brick, especially fireplaces...It's ugly...my entire outside of my house and fireplace has to be stipped.....house flippers did this mess. It is hideous.
@maddyhall4171
10 ай бұрын
Same
@davidsnelson725
2 жыл бұрын
You’re suppose to power wash the paint off….that gets in the brick pores and the mortar. I don’t know why you though peeling off the plastic was just going to take alllllll the paint off.
@BadHomeowner
2 жыл бұрын
It's not a good idea to power wash brick (or sandblast) -- high pressure can damage the mortar and the brick itself. Also this is inside my basement, so hard to use a powerwasher down there :)
@golondriz3
Жыл бұрын
Hilarious . The laughs were better than the DYI! I enjoyed that a lot! You should be a comedian!
@mattsanchez4893
3 жыл бұрын
Excellent demonstration on the actual job that paint strippers do
@HsingSun
4 ай бұрын
If is not fine if it didn't work well.
@shaffey01
3 ай бұрын
What if your brick isn't flat?
@AtmeLook-si8qr
Жыл бұрын
What do I think is not good at all 😅😅😅😅 this is pretty bad. All works pretty bad actually
@audx2338
2 ай бұрын
If the paint is that old, it was likely lead paint, right? Might need additional safety measures
@BadHomeowner
2 ай бұрын
Just don't eat it and you'll be fine.
@galaxys6238
4 жыл бұрын
Thanks for this video. It was very informative. I am a painter and have a job where I have to remove paint from exterior brick. So, I researched and bought peel away. It's currently on a small section of wall as a test and 48 hours is almost up. What are your thoughts on the peel away product?
@BadHomeowner
4 жыл бұрын
Overall, this method didn't work that well for my situation, but as with anything, ymmv
@Nonsense62365
Жыл бұрын
I used the same product on my exterior brick. Applied it over the latex water based paint! Without placing clear plastic over it! left it on over for 18 hrs. It did a great job removing the latex paint but not the oil base paint underneath. Then I applied a the gel it over the OB paint waited 3 hrs only removed 1 layer of oil base paint that’s remaining. It’s 1/32” of an inch thick! Washed it off with my hose to remove the excess strong smelling Gel! Also used a razor blade to remove a tiny bit of the OB (Oil Base Paint) and the gel. I’m going to apply the gel a 3rd time over the OB paint. My expectations are very low that all only remove a thin layer 1/128” of oil based paint and I’m gonna have to resort to probably sandblasting it.
@BadHomeowner
4 ай бұрын
Yea I think that's my problem
@darkraiknb4279
4 жыл бұрын
citrristrip from what i've heard is not that good anymore
@BadHomeowner
4 жыл бұрын
Yea, that's what I found. It's ok, not great.
@toniperez5791
2 жыл бұрын
It’s supposed to be a paper or fabric product NOT plastic FYI
@BadHomeowner
2 жыл бұрын
The instructions on the bottle (in the video) say "cover application area with plastic".
@bradshean2277
3 жыл бұрын
That stuff sucks you need peel away 7 works many layers you get what you pay for and this kid can’t talk too many fumes I think 🤔 and you need wire wheel and wire brush … amd this kid should go back to doing what ever he was doing before this bricks 🧱 just not for him
Пікірлер: 20