I’m glad I found your channel on a short, your content is right up my alley
@BrandonActionJackson
Жыл бұрын
Glad you like it!
@Mattittas
Жыл бұрын
My biggest tip would be to enable a draft shield in the slicer. It has done wonders for my garage printer! 🤓
@BrandonActionJackson
Жыл бұрын
I’m actually using Petg quite a bit more instead of abs
@covertpluto
Жыл бұрын
Do try some abs juice (dissolve some abs scrap into acetone) and spread it on the bed. Works wonders for me even with 60 deg bed
@deeply999
Жыл бұрын
Thats great... Keep inhaling those VoC's. Stop promoting dangerous habits
@billcarriveau
3 ай бұрын
Some of you people 😅😅😅😅
@Mikehatespigs
5 ай бұрын
Your first upgrade should be a.c. bed
@Mikehatespigs
5 ай бұрын
Only works for smaller parts look up 0:49 how nasa uses heat lamps or halogen used the ights to print peek n etc with smaller bulbs on each side the radiant heat actually helps and giv3s better results than an enclosure and your not exactly right in your video bud I've done all your talking about what the biggest successful print of abs 6 inches off the plate? It ne3ds heat evenly so it evenly cools and shrinks
Пікірлер: 9