For 15% off: i.refs.cc/osNNNSn3?smile_ref=eyJzbWlsZV9zb3VyY2UiOiJzbWlsZV91aSIsInNtaWxlX21lZGl1bSI6IiIsInNtaWxlX2NhbXBhaWduIjoicmVmZXJyYWxfcHJvZ3JhbSIsInNtaWxlX2N1c3RvbWVyX2lkIjoxNTcyMjI4MTg4fQ%3D%3D
@andrewzajak
3 ай бұрын
Honestly so much better than any instructions on their site! They should really link to your video.
@SerenityDragons
3 ай бұрын
Thank you so much for the kind words! Really appreciate the feedback! 🤘🏻🍻
@saralou123
5 ай бұрын
Thank you for making this! I just got time to put my enclosure together and while it looked pretty straightforward, I was glad to have your video to reference to double check I wasn’t going to screw anything up. 😂
@SerenityDragons
4 ай бұрын
Glade we could help!! Thank you for the comment! What ya keeping in your new enclosure?
@brandonmoore1705
6 ай бұрын
this guide was very helpful, thank you for making this
@SerenityDragons
6 ай бұрын
@brandon_iskindacool5261 Thank you! Glad it was helpful
@brandyboyd9102
2 ай бұрын
How did you stack the 18x18x24s on the bigger enclosure at the bottom? Also which enclosure is the bigger one?
@SerenityDragons
2 ай бұрын
Its a 4 foot exo terra that we put a divider in. We actually took two pieces of scrap 1x2 board, cut them down so they would span the entire length of the lid and painted them black. Then laid them across the top! They keep the dubia enclosures high enough so that a LED light can still fit and air flow isn't interrupted
@melissao643
3 ай бұрын
Any tips on getting the door lock set up?
@SerenityDragons
3 ай бұрын
Yes! Super simple. The little plastic bag with the lock on it has the instructions printed on a sticker. There is a small silver wire push pin in the bag. Place that in the little hole on the bottom of the lock. Turn to the combo you want, then remove pin. You should be set
@SerenityDragons
3 ай бұрын
Just dawned on me that you might be asking about installing the actual lock. 1)Place one rubber square on the back of the lock.2) Thread two screws through the lock and mat. 3)Then line up with holes on the door. 4)Place last rubber square on the inside and and thread the screws through it. 5) loosely apply bolts to those screws. That way it's easier to add the last 2 bottom screws.
@brandyboyd9102
2 ай бұрын
So there is supposed to be the rubber square on both sides of the glass. I tried that and the one on the inside keeps warping as I tighten the screws. :(
@SerenityDragons
Ай бұрын
@@brandyboyd9102the 1st design they came out with only had 1 thick black pad. That is the one in this video. The new design has 2 thin black pads. I'm not sure why is would be getting twisted on the screw. The hole in the pad might have not been punched out appropriately
Пікірлер: 14