How to assemble the charging cable for the Yamaha Jupiter Z, Mio, Vega Zr, and Jupiter Mx motorcycle battery starting from the road spool, kiprok, and battery. The first step we have to do is find out the color of the output cable from the road spool, namely: 1. The white wire is as new as charging from the road spool position on the top right and make sure there is current. 2. The black cable is for the kiprok mass or ground line and make sure it is connected to the motor body or frame, its position is on the left. and if it is not connected to the motor body then there will be problems in the charging line which will not be normal and the main light will break when the rpm is high or when the gas is on even though the kiprok is good 3. The red cable is the output current from the kiprok that goes to the plus battery through the fuse or fuse first. And its position is under the right pin of the kiprok socket, and make sure there is current. 4. the yellow cable is as the main light path that goes directly to the kiprok below the left and will come out again to the on of switch if you use the on of switch. if you don't use the on of switch, it will go straight to the far close switch. And to check the charging current from the road spool is good or not, we measure it using a multitester at 50 volts ac. and the result should be 12 to 15 volts ac. and if it's less then the spool is weak. and if it's more than 15 volts ace then the over volt spool is over current. Likewise, to check the kiprok output that goes to the battery plus, the result must be 12 to 15 volts Dc. And the size of the multitester must be at 50 volts Dc. Thank you very much to all #SUBSCRIBER# and viewers wherever you are, hopefully the knowledge is useful. Please #SUBSCRIBE# @SIDIK NURYADEN CHANNEL. If you have questions, you can write them in the comments. Tel/WA: 085863491419. Thank you very much.
- Күн бұрын
How to Assemble the Yamaha Jupiter Z, Vega Zr, Mio, Mx Battery Charging Cable Line From kiorok spul
- Рет қаралды 178,534
Пікірлер: 245