To get the V8FR-II to bind with the DJT module with both switches in the off position. Here is what I did:
With Rx unplugged, Tx turned off, both DJT switches in OFF position and jumper across Rx CH1/CH2 signal pins:
-Turn on Tx while holding F/S button on module to put module into bind mode (should hear beep every ~1s)
-Give power to Rx without holding F/S button, (magically) wave Rx over Tx and red LED should start flashing quickly.
-Unplug Rx and turn off Tx, then remove jumper from Rx pins.
-Turn on Tx, give power to Rx and light should go from slow flashing red to green.
I was having trouble at first cause I didn't remove the jumper after binding.
Please thumbs up if this video helped :)
Негізгі бет How to bind FrSky V8FR-II to Turnigy 9X with Frsky DJT module in D (telemetry) Mode
Пікірлер: 17