Hi guys in this video I show you how you can bleed the brakes by your self using the one person bleeding methop. Please like, and subscribe, THANK YOU!!!!!
Thanks for these videos man. I’m doing a brake bleed fluid change, transmission fluid change, and cabin air filter for a friend today stealerShip wanted to change 600 for all three services
@chucker77
Жыл бұрын
Best vid for the 10th gen civic yet. Well done!
@kingdomsheir7
9 ай бұрын
Thanks for the help!
@franciscotejeda1505
Жыл бұрын
Nice. You’re supposed to start bleeding from the rear passenger, then the rear driver and then the front passenger and finally the front driver side. But it should be fine.
@__emmanwell__
Жыл бұрын
You wanna bet a pizza 😅
@nexienriquez4972
Жыл бұрын
That’s the old school way. 10th gen is different. Great video. You did it the way it supposed to be.
@adamhutton4165
3 ай бұрын
How about not commenting on something you know nothing about? Honda mechanic here and not only does he do it correctly, he even shows you my manual. I charge $250 to do this exact job.
@timothylee2772
3 ай бұрын
@@__emmanwell__Do you press on the brakes for each bleeding on all four sections?
@coreturkoane5570
2 ай бұрын
@@timothylee2772 yes
@raczyk
3 ай бұрын
Can I swap my rusted bleed screw before pumping out the old fluid? Or is there any danger if introducing air when swapping out the bleed screw?
@SoHyped97
2 ай бұрын
Dumb question, but is 1 quart enough?
@raczyk
3 ай бұрын
Why does the brake fluid have to be above the caliper?
@Solrac77777
5 ай бұрын
Wonder is the bleeding sequence is the same for 11th gen? Trying to do my own soon.
@Hi-kv9bz
5 ай бұрын
nah they’re all the same line so it doesn’t matter
@frank8938able
7 ай бұрын
As ur pumping the brakes is the bleeder open or close?
@easye1311
6 ай бұрын
Open of course
@mrtoobad8857
8 ай бұрын
Hey bro by chance do you know where the ect 2 sensor is on the civic
@__emmanwell__
7 ай бұрын
coolant temp sensor? usually near the thermostat
@timothylee2772
3 ай бұрын
What was your mileage when you did the first brake fluid change?
@bruceyourface8330
4 ай бұрын
Noob question, is it mandatory to bleed them when you change brake fluid or you can just pour brake fluid without problem
@danielsong1323
3 ай бұрын
Yes. 1.) remove some but NOT ALL fluid from the reservoir 2.) add some new fluid 3.) crack open the nut on the caliper 4.) drain by pressing on the brake pedal 5.) until clear fluid comes out stop. 6.) make sure the fluid doesn’t run low on the reservoir 7. Done
@bruceyourface8330
3 ай бұрын
@@danielsong1323 thanks for the info bro!
@raczyk
3 ай бұрын
What happens if air gdts unto naster cylider? Is thatvan expensive fix?
@danielsong1323
2 ай бұрын
@@raczyk buy another bottle ($20) and rebleed them
@raczyk
3 ай бұрын
Do you have to buy honda brake fluid, or any will do?
@romanp1085
2 ай бұрын
Honda recommends to use their Honda DOT 3 brake fluid to prevent corrosion inside the brake system , they say if you try other kinds that you can run the risk of getting rust
@andrewcalles5703
9 ай бұрын
Why from the front left?
@__emmanwell__
7 ай бұрын
its what the repair manual calls for not exactly sure why
@vermontvermont9292
6 ай бұрын
@@__emmanwell__ has something to do with the abs system.
Пікірлер: 30