Halfords garage charged £20 to do this on my wife's car...I can do it now for cost of a bulb as the other side has gone. Thanks.
@blot100
2 жыл бұрын
after watching this I thought it so fiddly I'd go to Halfords (thinking 5-6 quid) but if it's £20 I'll have a go..
@blot100
2 жыл бұрын
I just went to Halfords for the bulb and they quoted £8 no matter how difficult the bulb change (and if they can't do it they refund)
@PortTalbot1
8 ай бұрын
Just in case anyone is wondering Halfords charge £4.19 for the bulb 💡 and £9 for fitting it. (February 2024)
@happinessstan1
3 жыл бұрын
I've had a nightmare with these bulbs. Trouble is locking the bulb holder back in position after replacing the bulb. I've had bulbs fall inside the light unit and the more you fiddle around with these bulbs the looser they become until they stop working. For the time I've spent on mine these last few days I think I'm going to take the bumper off and take the light off so I can access it easier or perhaps take it to Halfords who fit them for around £8.
@nonomiss9709
Жыл бұрын
Thank you so much. My father was getting upset about my car, luckily I saw your video you saved my afternoon and my ears. We're watching you from the France 🇫🇷
@focusedman5759
2 жыл бұрын
Just bought my daughter one of these and want to fit LED bulbs instead of original filament type, anyone know if these cars have a CAN-BUS system? Want to swap the number plate bulbs for LED too.
@BlatentlyFakeName
Жыл бұрын
My 2009 Abarth has a can-bus so I'm guessing yes for all the 500 models. I tried LEDs and they did not work, the polarity apparently needs reversing which means re-wiring the lights. Not worth it.
@blot100
2 жыл бұрын
I've bought a bulb and hit a hurdle at the first step. On my car the access flap (ooer) is held in place with Philips screws not a clip and they have been worn down prob by the previous owner...can't get one out at the moment. (BTW if you have the same a 'stubby' screwdriver is needed due to the wheel being in the way)
@blot100
2 жыл бұрын
WARNING: OK I love KZitem videos like this but sometimes they can lead you astray. I have a Fiat 500L popstar (2015) and there were some differences to that in the video that got me into trouble. 1) inspection flap removal This is secured by two Philips screws. It is confusing as they just seem to keep turning. I found out they are inserted into plastic lugs that widen on tightening. So for removal, they only have to be partially undone before pulling the flap out. 2) rubber cap is the same. 3) It's a different smaller bulb...I tried pulling it out and it shattered leaving some stuck in the fitting. I later found out the correct bulb for this car is smaller and is supplied ALREADY INSERTED INTO THE FITTING so the bulb with the fitting need to be pulled out as one unit. To add insult to injury the bulb I broke seemed to be fine (as in the elements weren't burnt out) and of course, after fitting the new one; no luck. Guess there must be a loose connection somewhere else...
@wbw7509
2 жыл бұрын
What a pain this job is - should be a simple task, but has designed-in difficulty, made even more-so if you have sausage fingers! Quick note: Bulb holder turn anti-clockwise to release it. Great vid
@johnbowles8121
3 жыл бұрын
Iv probably spent over an hour of my life trying to change these bulbs, i get pissed off and then drive to halfords. takes me 2 mins.......
@thomasbrookes2266
2 жыл бұрын
i dont know your name but i will call you god, thank you so much
@JOC-l3k
3 ай бұрын
Thanks for the very helpful video. Let's be honest; it's not a nice and easy job is it? Real question: why do they keep popping? What's the actual cause?
@PulpnPress
3 ай бұрын
Hi, if they keep popping, check the connection inside the bulb holder. If there is a bad connection to the bulb, it could contribute to short bulb life.
@mrmrsfowler665
3 жыл бұрын
Just tried this. You need hands the size of a 3 year old to even attempt to do this. Not a chance for a fully grown male
@barryriches6023
3 жыл бұрын
Great instructive video, especially the tips to avoid disasters.However it’s like working on a Matchbox toy so, being aware of my ineptitude in such mechanical matters, I’ll reluctantly be forking out and getting the garage to assist ! I’d turn a routine task into a financial nightmare…. the space they pack all those electricals into…. joke for home maintenance.
@ianevans67
5 ай бұрын
I thought the drl was the lower separate bulb with the green cap in your video its lower than the main assembly.
@greggproud
4 ай бұрын
Thanks, out of interest, what is the green block below for? Looks like a light fitting of some kind?
@PulpnPress
4 ай бұрын
Hi, the green socket if for the car’s wiring loom to connect to the light unit. When you remove the front bumper (for other works) you need to disconnect these.
@hamzahmohammed2402
8 ай бұрын
Just tried this and unfortunately broke the lockimg tabs on the bulbholder. Any ideas how i can fix or where to find a spare
@cmurphy7325
2 жыл бұрын
This is a very useful video - so clearly showing what you need to do I could do it by feel rather than sight. Thanks to another video I did it without jacking up the car but simply by turning the wheel. Luckily I have small hands and nothing got stuck, it took me about 5 minutes.
@simonsmith8920
Жыл бұрын
Perfect 0
@ruthholmes6109
2 жыл бұрын
Excellent thank you Perfect tutorial
@reverendodarn4295
2 ай бұрын
Thanks for the video, going to replace the bulbs in my daughter's car this afternoon.
@mick5119
6 ай бұрын
Great Video Mr oily Rag , very informative and very clear instructions thank for taking time to do these videos so helpful 👍
@timparker9235
Жыл бұрын
thanks for this video, I have just done one of my wife's - it was straightforward after seeing this. I did remove the wheel though to give better access, allowing me to get my head inside the wheel arch for a better look
@johnlightbody9942
Жыл бұрын
Would you be able to advise how lower lamp is adjusted lower please as high beam is far too high....
@billywhizz98
Жыл бұрын
Great video I recently changed the bulb on a friend’s car it was a Sid of a job I did it exactly how you did it I did after I done it think it would be easier to remove the headlight housing
@Cristo_Mario
2 жыл бұрын
thank you for the video - I made a small tool out of a piece of conduit pipe. Realised that there is no way to get it out with your hand, unless you have very very tiny hands.
@katrinahughes377
Жыл бұрын
whats the name of the small light below the headlamp. o thought that was the running light as it comes on during the day
@k05t
Жыл бұрын
What's your Fiat500's reg plate?How old is it?
@phjones01
Жыл бұрын
Excellent video and so nice to part that knowledge about the jacking points.
@katrinahughes377
Жыл бұрын
looks like you are changing the head light rather the running light
@michaelreeves6019
2 жыл бұрын
That's impressive that you got that off and we're holding a phone at the same time
@Alan-N
Жыл бұрын
Great video & camera work , appreciate the jack info 👍🇬🇧
@chookvalve
Жыл бұрын
My hands are too big for this job so I take the wheel off. My left bulb blows frequently but my right never does. Mystery!
@PulpnPress
Жыл бұрын
I would recommend checking the terminals inside the bulb holder. If the connection is poor, it will shorten the build life.
@gerardosalas9477
2 жыл бұрын
8:29 I wrecked that part with the emergency jack. The car should NOT have those arrows, it’s completely counter intuitive.
@domenicocimino4531
2 жыл бұрын
The arrows are indicators where the seam weld areas are strengthened to take the emergency jack. These points are only to be used with the correct emergency jack with the seam in the slot of the jack.
@blot100
2 жыл бұрын
Thanks Mr. Rag really appreciate these. Sure looks fiddly but someone posted Halfords charge £20 to fit so I'll give it a go
@blot100
2 жыл бұрын
When I got the bulb they said £8...
@AustinFernandez-kr5ue
5 ай бұрын
Really well explained. Thank you!
@martindeaker5875
2 жыл бұрын
Really helpful video, particularly appreciate the tip for where NOT to jack the car!
@livinggnome
Жыл бұрын
Thx from Poland for this handy film
@JOC-l3k
10 ай бұрын
Many thanks sir.
@az7500
3 жыл бұрын
Great Video. Thanks, mate!!!
@nickp1548
11 ай бұрын
What's the green connector below please?
@PulpnPress
9 ай бұрын
This is electrical connection between the lamp unit and the car.
@mastap2002
Жыл бұрын
Thanks amigo
@saveriomule3026
3 жыл бұрын
Come sostituire filtro anitacolo
@kimbrooks240
3 жыл бұрын
Spot on thank you
@Owlstare
2 жыл бұрын
Thanks - used this today👍
@StopTargetingOurKids
Жыл бұрын
It looks easier to take off the bumper lol
@domenicocimino4531
Жыл бұрын
That is a viable option, however you run the risk of breaking the plastic brackets that hold the bumper to the wings, also you will need to remove the fixings holding the wheel arch liners to the bumper.
@StopTargetingOurKids
Жыл бұрын
@@domenicocimino4531 mine were broken when I bought the car, as of last night my shift cable snapped. Going to be an ugly repair in my driveway lol
Пікірлер: 57