As below, you didn't torque the bolts, why? Also, this appears to be a typical garage job, because you never checked or lubed the sliding pins or cleaned the calipers. Some people argue it shouldn't be done, but in my fifty years of changing brake, I do as I was taught and put copper-grease on the caliper contact surfaces. The few times I have taken my vehicle to a garage over the years to have the pads replaced, I have always had to take it home and lube it myself to get rid of the squeal.
@autodocuk
5 жыл бұрын
Thank you for your valuable feedback. We understand that when replacing mistakes were made, and we are working on them and we will not allow them. Best regards,Autodoc!
@after567
Жыл бұрын
Wrong for 12mm socket. 13mm was correct. Please upload more video of w639❤
@autodocuk
Жыл бұрын
We're sure your comment will be helpful to many of our viewers.
@phneutraal7995
3 жыл бұрын
How do you know how to adjust the 'hand'brake, i see dat he ajusts it with the screwdriver through te hole. I think them brakeshoes for the handbrake almost don't wear but i see him adjust it quite a lot.
@autodocuk
3 жыл бұрын
Please specify the exact fragment in the video to find out what do you mean.
@SourceOfObesity
3 жыл бұрын
Tighten until the disk doesn’t turn, then go back 7 teeth. This ensures that the handbrake pads are close to the drum, but not touching :-)
@bohicajohnson7203
2 жыл бұрын
No loctite used?
@autodocuk
2 жыл бұрын
The replacement takes place without the use of a cubit.
@dunkelbuntmoonraker2181
Жыл бұрын
Hi, when i try to take the discs off it feels like its being pulled back in by something.. the handbrake is off.. any ideas?
@autodocuk
Жыл бұрын
We do not have such information, we recommend that you consult your mechanic.
@MrZeljko88
5 жыл бұрын
Hi how long can you drive a mercedes vito 115 once break worn light comes on?
@autodocuk
5 жыл бұрын
Thank you for your feedback.You should not operate the car in case of faulty lighting, especially in the dark. Whenever possible it is better to quickly replace all the faulty parts of the lighting. Best regards, Autodoc!
@Equinoxdark
4 жыл бұрын
@@autodocuk Laughed too hard at this reply. Clearly the question was misunderstood. So you must replace the brake warning light... especially in the dark... LOL.
@bohicajohnson7203
2 жыл бұрын
Where is the wear warning sensor?
@autodocuk
2 жыл бұрын
Basically, the sensors are connected to the pads themselves, but there are electrical sensors and a sound wear sensor, to check which sensor is on your car we need the complete data of your car.
@hoveylu7231
5 жыл бұрын
What are the torque specs for carrier and sliding pin bolts?
@autodocuk
5 жыл бұрын
Thank you for your feedback! Unfortunately, we can`t specify the torque settings. We recommend you look it up in the vehicle details. Best regards, Autodoc!
Пікірлер: 18