Nakrętka od półosi jest jednorazowa. A tutaj kolega chyba tą samą przykręcił
@sala8704
10 ай бұрын
Well done.
@slavicshop2398
10 ай бұрын
Thank you!
@areksowinski9805
3 ай бұрын
W tym przypadku gdzie oba przeguby są padnięte to się wymienia całą półoś bez takiego drutowania. Cała półoś jest tańsza niż dwa przeguby.
@BlakeCDS
7 ай бұрын
Same as ford mondeo mk4 thank you
@slavicshop2398
7 ай бұрын
I know that some models of Ford are the same. Thanks for confirming that!
@patpaft4636
Жыл бұрын
Nice satisfying video, keep it up man! Im wondering if I need to replace inner joint, because there is some play on the left axle. My main concern is some clicking noise when reducing the gear or letting off clutch to fast
@slavicshop2398
Жыл бұрын
Hey , thank you! Yes it could be , you can check by taking of and taking a look inside .
@chrisburn7178
7 ай бұрын
I need to do mine as I just noticed it dumped a load of grease on the undertray. Except I didn't know what it was until after I'd finished replacing my control arms, so now it has to come apart again 😔 I think it's easier to undo the three nuts holding the ball joint carrier to the control arm, I took the knuckle out instead and damaged the ball joint boot because I only had a fork type remover.
@slavicshop2398
7 ай бұрын
Good luck with that!
@911aido
5 ай бұрын
Do you have to empty transmission oil before taking axle out?
@slavicshop2398
5 ай бұрын
No, it was full. The oil doesn’t come out .
@michakalabinski7453
8 ай бұрын
Nie udało się wyjąć sworznia , to odkręcamy całość ? Nie ładnie . Wypada mieć ściągacz .
@slavicshop2398
8 ай бұрын
Please write me in english. Thank you.
@dawid31m
3 ай бұрын
@@slavicshop2398 he ask you why you dont use special toll to replacment out joint.?
Пікірлер: 18