This video was very helpful - got me through it just fine. I'm not sure why some others are complaining about you not showing every tiny step - those things I had to figure out didn't take much brainpower, just thinking it through and being careful. THANK YOU!
@SuperATVMedia
Жыл бұрын
Thanks for the feedback! We always appreciate the support and are happy to help!
@randy0552
3 жыл бұрын
I would've liked to seen what inspector gadget extension she used to get to those three oil filter cover bolts. They just flew right past that part.
@Oliviaswaxtech
2 жыл бұрын
Nothing to see here! 😂
@richardmonson8657
Жыл бұрын
Also flew right past removing rivets on access panel.
@ronberg8028
Жыл бұрын
8mm socket with a SHORT extension on a ratchet. Coming in from the driver's side might help the angle.
@ronberg8028
Жыл бұрын
Really?!? They're plastic pop-rivets. Use a thin screwdriver or the fork on a short prybar....
@lalo-Espinoza
3 жыл бұрын
How often is supposed to be done?? Every how many miles or hours??
@ncbrothad
2 жыл бұрын
Favorite mechanic
@HighCountryRambler
Жыл бұрын
Thanks, made it a cake-walk. Now, for the million dollar question, how does one reset the maintenance required message after changing the oil on the Trail 1000? Everything I've found points to using the 'override switch' which the Trail doesn't have...?
@SuperATVMedia
Жыл бұрын
Your owner's manual should have a reset procedure, but most are as follows: 1. Select PARK. 2. Turn ignition switch to ON. Do NOT start engine. 3. Set the cluster to odometer display. 4. Press SET button on the multifunction gauge and keep it pressed until step 6. 5. Switch the high beam On-Off three times rapidly. 6. Turn ignition switch to OFF. This has to be done VERY quickly so it might take a few tries.
@hxlym001
4 жыл бұрын
The service manual states as follows:- "LUBRICATION SYSTEM Verifying Engine Oil Level NOTICE Operating the engine with an im-proper level may severely damage engine. NOTE: Check oil level when engine is cold. " In your video you advise to get the engine to temp. is there a reason for this change?
@andrewdoniec4145
3 жыл бұрын
She added 2.1 quarts to the oil, why would you think the level would be low enough to damage the oil? She's just checking to make sure there aren't any leaks and then doing a final check on the oil level after all checks out...that's all folks.
@kiesersozay6813
3 жыл бұрын
you rock girl ...peace !!!
@richardmonson8657
Жыл бұрын
What’s the trick to removing rivets on panel to access oil filter?
@SuperATVMedia
Жыл бұрын
We use a plastic rivet removal tool to remove them. You can find these tools fairly cheap from a dealership or Amazon.
@richardmonson8657
Жыл бұрын
@@SuperATVMedia thank you
@davidj5718
4 жыл бұрын
How do you reset the maintenance light ? When I look it up all I can find is other models
@mackenziebeal7164
4 жыл бұрын
david johnstone im trying to figure out the same thing
@danielcad23
Жыл бұрын
Wheres the drain plug located??
@SuperATVMedia
Жыл бұрын
If you skip ahead to the 17 second mark, we will show you where it's at on the CanAm Maverick Trail.
@danielcad23
Жыл бұрын
Thnk you
@kklastow
3 жыл бұрын
#Superatv what tires are on the maverick trail in the cover for this video?
@SuperATVMedia
3 жыл бұрын
Those are our Intimidator tires: www.superatv.com/intimidator-all-terrain-utv-atv-tire
@viktorvaaranen9154
3 жыл бұрын
Thanks a lot!
@danielcribbs7312
2 жыл бұрын
What brand of lift do you use for your sxs?
@dad1967
Жыл бұрын
Your mom
@davidn8045
4 жыл бұрын
It would have been nice if you had taken a head on shot of the oil filter. The camera angle was not good understanding that you were working in a tight spot. Also I have never in my 50 years of driving checked the oil level on a hot engine. Oil needs time to drain back to the oil pan. You do it when it is cold. I suspect you overfilled the oil on this engine.
Пікірлер: 28