Thank you for this video! It saved my Tascam from lying useless on the shelf.
@Stupid_you_so_stoopid_UHF
6 жыл бұрын
Thanks for making this video ! Got a deck 3 weeks ago and because of you I got it running. Hooray!
@markgosselin4608
6 жыл бұрын
I followed your video and you helped me save this recorder from the trash, Thank you so much!
@bobjerome5390
4 жыл бұрын
this unit is better than the later servo 238 that is going crazy on the tape speed
@BackToUlfsRuhtz
5 жыл бұрын
Thanks! Whats the music youre testing with?
@thefastandthefurious1
Жыл бұрын
I have a 133 and when I press any of the play, rw, ff etc buttons nothing happens. There no click sound of the motor engaging or anything. Do you think it’s the belt or something else?
@stevegeorge6131
3 жыл бұрын
The lift assembly belt is : 6.5" x 0.65 " square
@jidissafi7413
3 жыл бұрын
I'm guessing that's .065" on the square part.
@gokomets77
5 жыл бұрын
Very similar to the 122 but what did or how did you handle the black plastic lever connected to the dial cord and door mechanism? Has to be removed in order to install the main belt...
@deanguando1335
5 жыл бұрын
Hi Bruce - I picked up a 122 that needs belts, idler tires, and pinch roller. Senseless to do this job unless you replace all these items. I may want to pick your brain down the road after I acquire all the correct parts. The service manual is useless. I notice that on this video that an instruction sheet came with the belt. Every bit of information can be helpful. I'm not sure about what you had mentioned.
@gokomets77
5 жыл бұрын
@@deanguando1335 This plastic "rod " or lever is held by 2 "C"clips and has to be removed in order to replace the belt and I'd rather not move the dial cord that is attached to it as the door may not work afterwards. I need to find a manual on line and also the idlers are still good.
@EytanKoch
3 жыл бұрын
Hi, I have a Teac model 124 syncaset....Have you seen this one? How similar do you think it might be to the 133?
@DunQuDeYi
3 жыл бұрын
I never opened a 124 before so I can only see it based on the observation. I think it would be similar. However, it you buy belt from EBay. I believe those sellers have detailed paper instruction upon request. So you can ask them if they have it before you buy.
@richierich9696
2 жыл бұрын
Do you have any idea why one channel is not working? I tried unplugging the rca lead that’s working to the channel that’s no working. Nothing. It’s dead
@buster4736
Жыл бұрын
Im tying to find a belt replacement for the 133, what was the size of the one you replaced?
@DunQuDeYi
Жыл бұрын
It has been a long time so I do not remember. However, you do not need to know the exact size. All you have to do is to make a guess of the belt width and lengthn. Then buy the "assorted cassette flat belts" from ebay. It will have one fit. Much cheaper than buying a specific one.
@buster4736
Жыл бұрын
@@DunQuDeYi THXs for your reply. Do you have the document with process description still from the belt exchange?
@rcary
Жыл бұрын
I finally changed belt. But the belt keeps falling off the small motor wheel. Not sure why. Did you experience this after you installed it?
@DunQuDeYi
Жыл бұрын
No. I have not experience it. However, if the belt keeps falling fall, there are usually 2 causes: 1. The belt is too long and you will need a shorter belt so that it is tight. 2. Your belt is too thick. There is a 3rd one but rare, that is your motor spins reversely.
@rcary
Жыл бұрын
@@DunQuDeYi I bought the original 133 belt. The belt when play slips off by the motor. And then the music sounds bad. I put the belt straight and it hit play and the belt goes over the wheel on the motor side.
@322HzSquareWave
4 жыл бұрын
Do you know what size the shaft is for the knobs?
@DunQuDeYi
4 жыл бұрын
Sorry. I dont know. I dont have it any more.
@mobydog04
3 жыл бұрын
Where to buy parts???
@DunQuDeYi
3 жыл бұрын
I buy everything from ebay
@rcary
Жыл бұрын
Why do you remove pcb board?? Can you do it without this step?
@DunQuDeYi
Жыл бұрын
You dont have to remove it. But remove it make it easier for your hand to move around.
@rcary
Жыл бұрын
@@DunQuDeYi I got the tape player out and I cannot see how you put the belt onto the flywheel. The big wheel is attached to the body . Do you have to remove big flywheel to put belt onto small wheel?
@DunQuDeYi
Жыл бұрын
no. You dont need to. You should be able to carefully insert the belt in it.
@rcary
Жыл бұрын
@@DunQuDeYi I put belt back. Now work!!!! I think maybe twisted 🥨 I records plays. Alot of time to do this, but happy now. 😀😀
Пікірлер: 29