This video will show how to change the code on a MultiCode remote and receiver.
www.thegategeek.com
Transcription:
This is the MultiCode remote, that I'll be changing the code on today.
First I would like to show you how open the remote properly
The best tool is the visor clip. We are going to slide it out and use it to pry it open like this.
And the reason why, is this little tab here, will rake against the middle dip switches. So if you open it like this.
It will change the dip switches with this tab. Just a quick tip on opening the remote.
Now for the MultiCode receiver, you'll see this in your gate operator. This receives the signal from the remote.
You'll notice these tabs here and here. The cover comes off by squeezing the sides and lifting the cover. The board is located in the cover.
And there are the dip switches that match the remote here.
You can change these switches with a small screwdriver or pen.
Like this.
You'll want to match the dip switches on the remote to be the exact same as the receiver
These are now the same
The switches have only two positions on or off
And now we can put the cover back on like this,
and now the receiver,
put the top clip in first,
and squeeze the sides to put it back together.
Негізгі бет How To Change The Code On A MultiCode Remote And Receiver
Пікірлер: 58