Pro tip for anyone else doing this: When pushing the seal in, empty/clean a standard sized canned food can, place open end of food can over the seal, use a mallet to evenly seat the seal. Saw this in another vid. Bless
@2enjoihsu
10 ай бұрын
same things works with a 2"" PVC cap!
@MOE13576
8 ай бұрын
Thanks yall
@missiletm
11 ай бұрын
Merchant Auto is the best for Duramax parts. I had a leaky seal on my Alison trans where the wires connect and the connector was full of fluid and caused hard shift into second. They were the only ones that not only had the part but also helped me diagnose the problem as well.
@weldmaster80
Жыл бұрын
Huge help, my buddy was talking about pulling the engine and stuff and I'm like... That doesn't sound right... And now I know. Big thanks!
@MOE13576
8 ай бұрын
Different seal maybe...atleast I hope so
@jordanlalone5364
Жыл бұрын
Finally a guy who doesn’t use fancy tools and says “DIY”
@zachreece8410
8 ай бұрын
To future people doing this job, flathead screw driver and a hammer, use the lip of the seal and hammer it out. Prying at it will take hours.
@wiredmusic915
2 жыл бұрын
Thank uou! Need to see this for my 09 Silverado
@TheJDB65
6 ай бұрын
Great video man. Thx a ton! My ‘07 duramax has been leaking for years lol
@DanielFigueroa-tm1yv
2 жыл бұрын
Hi did the seal stop the leak after four months or so or did it start leaking again?
@jasonmoore6419
11 ай бұрын
I watched one dude use an empty vegetable can over the gasket and tapped it with a rubber mallet to get it flush and tight.
@montanafuller6266
8 ай бұрын
We all got into our dads tools when we were younger
@ProudPapaw88
2 жыл бұрын
Great video Dustin T. Very informative. Thanks for sharing.
@AdaliMatute-uu5ui
5 ай бұрын
Napa auto parts 22049 parts #
@junebug8882
3 ай бұрын
Thanks for showing me bro👍2024.. What
@christophermoreno3668
2 жыл бұрын
Keep these videos coming!
@fizzybillylah3816
Жыл бұрын
I’m pretty sure that is a dust boot. The seal is inside the unit I think
@Hunter-hv7ei
Жыл бұрын
No that’s the seal and dust boot made into one piece
@treyhansen6269
2 жыл бұрын
Did u try the gm dealer
@jasonmoore6419
11 ай бұрын
Before you put the drive shaft back together make sure the medal seal on the back of the slip yoke isn't leaking.
@pwmarquardt
4 ай бұрын
Did you leave the link to Merchant Auto?
@stevemartin8488
Жыл бұрын
remember to clean driveline yoke
@DustinT
Жыл бұрын
Great advice
@AD-iw4vy
2 жыл бұрын
20 ft lbs on the cap retainer bolts. Be sure to not let those caps fall off as there are about 67,000 needle bearings in there. Or so I hear. Luckily I haven't had them fall out.
Пікірлер: 27