Thanks for watching. Let me know what you think in the comments below. More videos like this here: kzitem.info/door/PLmgCmljtdCzWMExyPXgSeeJZYwOA1Ocj7 Click To SUBSCRIBE bit.ly/RevelatorAlfSubscribe
@taylorpatnode6789
7 ай бұрын
Thank you for being the only logical dude on youtube that doesnt give an hour long line of bullshit, before the how to.
@tonytripp1284
2 жыл бұрын
I for one enjoy your videos as I've learned more from you than some of the self-help vids out there.
@bodeine454
2 жыл бұрын
We have a 2005 Dyna Wide Glide, I believe that the procedure would be pretty close to the same for it. I can see and feel that there's a front end alignment issue with ours. It even pulls to the right when I let go of the handlebars when riding it.
@RevelatorAlf
2 жыл бұрын
Yep check your fork alignment and bearings too if say
@bodeine454
2 жыл бұрын
@@RevelatorAlf Will do 👍
@sportster88
Жыл бұрын
Thanks for the fork adjustment tips Alf! I never would have thought of that. Was John the Revelator an influence on your channel name?
@RevelatorAlf
Жыл бұрын
More a twist on the bible but that in part too as I first call it that as well for a few videos when I started
@doublenickel1000
Ай бұрын
With 6-foot long extended forks?😄
@chrisvantassel8867
2 жыл бұрын
I have a 2020 Lower Rider S, from day 1 it has fought me on right hand turns, I have to push the right handle and pull the left to keep it from trying to stand up. It corners left perfectly. If I let go of the bars the bike falls to the left when go straight down the road......it gets fatiguing.
@RevelatorAlf
2 жыл бұрын
That is not set up properly. You need to check wheel and fork alignment as well as steering head bearing settings too by doing a pull test
@hundo123
2 жыл бұрын
hello my friend my 03 dyna turns farther to the left than right,is that normal? when turn to left signal almost hits tank but to the right its a good inch from signal to tank.
@Dzinbhudist
Жыл бұрын
Check your triple tree “stoppers” there should be two one per side, if your bike has been in accident often they break
@timblackburne77
6 ай бұрын
Excuse me for this. I'm a car mechanic, for a long time, and I just can't see this making any difference. My M8 softail pulls left like many others (Australia) and recently I changed the fork springs to lower it. The forks are 39mm, and slide into the triple clamps which are roughly the same wide. Unless the forks are bent, if they slide easily up through both triple clamps, there is no way they could be misaligned. There is just no room for movement. Even if there was a fraction of movement, I doubt that would effect the bike in any noticable way. The only thing I can see that would effect how the bike corners is front wheel tilt to one side. Maybe one fork has more or less oil than the other? Maybe one spring is weaker than the other? After changing my fork springs I was very careful with oil level, fork height, etc. I noticed no difference, however the tyre is nearly worn out, so in my case I need a tyre first, then see if it stops pulling to the left or not. But even in saying all that, the front axle will hold the wheel perfectly upright. I want to fix my pulling issue, but I do not believe its the front causing it.
@jxlharold236
2 жыл бұрын
Alf,, doing this with single disk front brake will cause miss alignment (works oke with dual front disk)). I would suggest push bike to a wall and press wheel against it.
@RevelatorAlf
2 жыл бұрын
yes true but if its within parameters it's still fine, hence why there will be a difference pulling from either side
@hitechrr
Жыл бұрын
My new 2023 Harley tri-glide is out of alignment and the dealer tells me that it can't be adjusted.
@RevelatorAlf
Жыл бұрын
Ask for your money back or a free replacement then I'd say
@Flyingscotsman3
2 жыл бұрын
You'd be long retired Alf, if ya had a quid for every time you've had that bike up in the air mate.👍🏍
@RevelatorAlf
2 жыл бұрын
Ha ha tell me about it
@coreylaber2731
2 жыл бұрын
Can we get a close up for those who don’t know the terms yet😬(me)
Пікірлер: 22