Hi, can you let me know of the difference in the light bulb, when adjusting the volt on the avr card. And should you get the same both ways, lower and raise the volts. And how the lights are supposed to be lit, is the one one you are testing now a good or faulty one. Thanks.
@t.r.channel5982
2 жыл бұрын
capillary ජෙනරේටරය panel data set in ටිකක් තියෙන මං එවන්නද
@cajolansang3231
2 жыл бұрын
hello can you make a video for this charging a 72v battery? let see if what amps stable on charging.
@subramanimani7662
Жыл бұрын
You checking DC volt bulb is DC or ac bulb sir. F1, F2
@oshan_rm
Жыл бұрын
This is AC bulb 100%
@nipunsproductions7451
2 жыл бұрын
1.5kw wage genarator ekakaka avr eka weda karana heti kaya dennako .
F+/F- kiyanne Dc out ekka neda ethanata LED 230 bulb ekka neda set kral thiyenne e bulb wada kranne kohomda poddk kiyala denawada wada kran widiha vedio dannko
@thusharasampath3029
3 жыл бұрын
Aka dc bulb akak neda....
@oshan_rm
2 жыл бұрын
Na AC
@electricaldhanu1434
2 жыл бұрын
ethanata voltage kiyak enawada kiyala denagaman video dannwda abirupana video poddk therenne nane
@ibrahimksesay9955
2 жыл бұрын
Hi, pleas why is my AVR putting out only two phase and making the neutral as phase on a three phase gen
@Musliperanto
13 күн бұрын
Ac bulb? Light via the exciter output?😱
@ماقل.ودل
2 ай бұрын
hi thanks for the great work I'm asking if i can disconnect one of the sensing input 7 or 8 until the motor tourn on high speed 1500 then connect it back to have full output directly? Would that harm any of the avr or generator?
@ماقل.ودل
2 ай бұрын
the engine must run in pre-heat and idel speed for 36 seconds in same time it gives 25 hz with 190 volts and I'm afraid that it will damage some equipments so I want a way to disable the avr until the 36 pass and the engine speeds up to 1500
@carloschimilio3185
2 жыл бұрын
something seems unusual on this video. How can u regulate voltage on a LED or compact fluorescent bulb? i stand to be corrected.
@oshan_rm
2 жыл бұрын
Exitor Output Voltage is regulating.
@oshan_rm
2 жыл бұрын
Sir! When the AVR receives 230V, the dc current emitted from both (f +) and (f-) decreases, and the light in the bulb decreases. When increased, the bulb glows brightly. He can also take the AC power that comes out little by little when he gives us more or less power to the Amcher coil or exitor winding. With control.
@SohanLal-om9cn
3 ай бұрын
Avr. Single phase 220volt ac supply avr ki output 300 volt dc voltage veri nehi hote kia falut hai
Пікірлер: 38