I have a 74 chevy nova just bought a intake manifold of ebay. ... now need a carburetor to install
@edgargalindo5834
Жыл бұрын
Need a manifold to convert this to carburetor engine is 2.8 s10 1994
@gordocarbo
4 ай бұрын
300-36 Z high rise intake, 90s era Wish you guys would start casting these again my fav ever.Everyone has an eddy air gap, pass! If runner /plenum volume was increased a hair I wouldnt complaint but as they were...need one! Have any older ones unsold laying around? So cal
@bobswinehart3646
5 жыл бұрын
Nice video. Thanks .i made the correct choice because of this excellent information.
@paulwhite6250
3 жыл бұрын
Volumetric efficiency is most important with this issue. That includes carbs, intake manifold, cam, valve springs, and exhaust systems. It depends on the use of the car.
@ItzDarealJacquan
4 жыл бұрын
I have Stock Engine
@michaelparadisis4076
5 жыл бұрын
Nicely presented- thanks for this.
@kansasindependent4015
Жыл бұрын
Just out of curiosity what intake manifold would you suggest for a 1981 Chevy 305 5.0 liter engine I was thinking about going with the Brawler 650 CFM square bore carburetor 🤔
@gordocarbo
4 ай бұрын
600 would be more than enough. Love spreadbores for the st esp a 305
@voodoochild661
3 жыл бұрын
The longer the runner the more the torque... so why would a short runnier intake make loss top end power ?
@crashnburn3635
3 жыл бұрын
Does a cast iron intake effect rpm range?
@chomin3025
3 жыл бұрын
crash 'n' burn no
@ItzDarealJacquan
4 жыл бұрын
Hello I'm Asking what's the best intake for 2007 mercury grand marquis
@gordocarbo
4 ай бұрын
probably what you already have. Esp if its stock.
@waterboy46
5 жыл бұрын
What's the best intake for a 1988 Ford bronco 5.0 L
@HolleyPerformance
5 жыл бұрын
That all depends on a lot of variables?? Stock or modified engine, what cam? , carb or EFI? , 2 or 4 barrel? , auto or manual trans? , gear ratio of the rear end? , Is it a stock vehicle driven on the street or a stripped and modified Bronco for off road use? thx J
@lt.schlechtnacht9414
4 жыл бұрын
@@HolleyPerformance Alright well how about this? Stock 350 with a performer RPM intake with a 4 barrel holley on it. automatic 4 speed overdrive transmission. Not sure what the gear ratio is think its stock. Its a 85 C20 i want it to be a hot rod. i drive it only on the streets and i usually punch it
Пікірлер: 19