How to clean a M&P Shield EZ 380 Semi-Auto Pistol:
Step 1: Before you start cleaning, make sure the firearm is completely unloaded. Rack the slide and drop the magazine. Also make sure to look inside and visually/physically inspect the chamber.
Step 2: To disassemble to the gun, rack the slide back and pull the take down lever till it is pointed completely down. Release the slide to go back and keep pulling until it completely releases from the gun.
Step 3: Take the recoil spring and guide rod assembly out of the slide. Remove the barrel by sliding it forward and tilting it up at the same time. Your gun is now fully disassembled.
Step 4: Now to cleaning. Take the barrel from the rear and insert your dry brush. You should see dust if the gun is dirty enough. Make sure to grab the brush by the T-handle so the brush rotates in and follows the rifling through the barrel. Once finished, put to the side.
Step 5: Take your utility brush and dry brush the side. Use a toothbrush if you do not have a gun cleaning utility brush, it will work just as well. Make sure to hit all the crevasses, channels, and rails. Take the lower and repeat the same process.
Step 6: Now time to clean. Take your solvent and insert your patch into the patch holder. Soak the patch in solvent and run it through the bore in a back-and-forth motion. Take the same patch and rub the feed ramp as well.
Step 7: Take the slide and brush, with solvent on it, and brush the slide again, the same as before. You can get aggressive with this process if you would like, it will not do anything but help you. Make sure to hit all crevasses again. Repeat the same process with the lower. Make sure all metallic parts have been brushed of excess carbon. Take a dry rag and wipe all solvent off. Use a Q-tip to dry all excess solvent while making sure to pay attention to all channels and crevasses.
Step 8: Take your gun cleaning pick with a patch underneath and use this to clean what your Q-tip did not. This is imperative step before you lubricate the gun.
Step 8: Going back to your barrel, take the dry brush and from the rear of the barrel and push the brush through about 4-5 times.
PRO TIP: Using the same dry brush, put a patch over the tip and push it through the barrel. This will clean the gun even more!
Step 9: Time for lubricant. Take your patch through your patch holder and put your chosen lubricant gun oil on the patch. Run this through the bore of the barrel. Repeat this process again.
Step 10: Take your slide and directly put your oil on the gun, making sure there is not too much excess. Use a Q-tip/pick and spread the oil out evenly throughout the slide.
Step 11: Repeat this process with the rest of the gun.
Step 12: Time for reassembly. Take your barrel and place it into the slide. Next, take the recall spring aligning the tip with the gun. Put your slide back in using the rail guides and lock it back. Flip the take down lever back up and you’re done!
Step 13: Double check the gun is working properly by sliding the empty mag back into place and pulling the trigger. Your gun should fire correctly.
Interested in learning more about safely and responsibly while operating your firearm? Visit www.concealedc...
Негізгі бет How to Clean a M&P Shield EZ 380 Semi-Auto Pistol
Пікірлер: 15