How to clean the shaver head
I will clean the head of the Philips electric shaver for dry shaving.
I will use an old toothbrush, water and detergent for cleaning.
I press the button and take off the head from the electric shaver.
The body itself is an electric razor. You can not clean it under water. Therefore, I clean it with a toothbrush without using water.
The hull is cleaned.
I turn to the head with knives. The head must be disassembled and decomposed into parts so that later, during assembly, everything will be assembled, as it was. Each knife should be placed exactly where it was taken from.
The fact is that the blades on the shaver heads are self-sharpening. During operation, they are ground to the grids in which they are and, accordingly, self-sharpened. If you mix and put the blades from one grid to another, the razor will stop working normally. Shaving will tear your hair and it will take a very long time for the knives to grab onto the new mesh.
In the center of the shaver head there is a retainer of grids with knives. I turn it counterclockwise and remove.
I take out the remaining elements of the head and lay them out so that during the assembly there is no confusion and all the elements were in their places.
I start cleaning parts of the shaver head.
I clean all these parts under water. On the toothbrush add detergent that dissolves grease. Using a toothbrush, thoroughly clean the shaver body.
I rinse and the first part is cleaned.
I put it in its place.
Now I will clean the knife retainer. I also use a toothbrush, detergent and water myself.
The second part is cleared, returning it to its place.
I start cleaning the grids with knives. Inside each grid are knives. They are taken out.
I take one grid with knives, take out the knives and start cleaning.
I use a toothbrush and detergent. First, clear the net itself. Knives can be wetted so that they are soaked while the mesh is being cleaned. If the dirt is poorly removed, then a match can be used to help. It is soft and will not damage the net or the knives.
Cleared the mesh, now proceed to clean the knives.
Thoroughly scrub all the dirt from the knives.
I rinse the cleaned parts, set the knives back into my mesh and send them to my place.
In the same way, in turn, I clean the two remaining grids with knives.
After I cleaned everything and laid it out in the same order as I took apart, I proceed to the assembly of the electric shaver's head.
I put all the grids with knives into the body of the shaver head, each in its place.
I set the knife lock into place and turn the latch, which is in the center, clockwise.
That's it, the shaver head is cleaned and assembled. You can install it on the body of the shaver.
Checking how it works. All perfectly!
Негізгі бет How to clean the shaver head
Пікірлер: 20