Do you know why my cyan little cartdridge is the only one that doesn't have ink in it? I tried following this tutorial but noticed that the little box you took out from the printer doesn't have ink... so i'm assuming the ink isn't getting to that little box from the wire... so i'm not sure what i need to do?
@kevinsavage5183
Ай бұрын
I have just discovered the same issue with my yellow. I'm hoping you found a solution you can share?
@marcm.983
Ай бұрын
Like the straight-to-the-point video. Second time using it to clean my ET-2720.
@mglaser1953
11 ай бұрын
The user manual is wrong about the syringe. Go back to your first arrangement but switch ends so the yellow piece is attached to the syringe. You then have a nice right angle and easy access to the ink inlets.
@juliush1297
6 ай бұрын
Your vid is the only one that helped thx
@JenetteHasenpflug
2 ай бұрын
Worst printer ever made
@petersplat6164
7 ай бұрын
I would strongly suggest to make your videos before drinking rather than after. Or else have a friend hold the camera for you. I got my printer working, thanks.
@ElissaStern
2 ай бұрын
There is a lot of ink coming out of the print head onto the paper towel, but still printing blank other than blue. Any ideas?
@teekay3498
Жыл бұрын
Where did you purchase your kit
@SweetRoseBuD3
Жыл бұрын
Where do I buy the kit?
@BowChickaWowWow
4 ай бұрын
Epson 2710 is same way to access printhead.. So thank you for a great video.
@itsjessicavictoria8834
10 ай бұрын
Do I not have to clean tubes/cartridges?
@brolicartrixing4111
10 ай бұрын
Thank you very much. I appreciate the info about to order that kit
@myasamantha2007
6 ай бұрын
Worked Perfectly, thank you
@StarsHallow
8 ай бұрын
What’s the hold button ?
@tonyrome068
6 ай бұрын
great job
@pzazzera
10 ай бұрын
Left the cleaning solution in for an hour. Plugged it in and pages are totally blank
@tonyrome068
6 ай бұрын
You want to flush it through
@nekaalston5712
Жыл бұрын
What size is the hose used
@RozlynTaylor
Жыл бұрын
Can i leave the ink inside or do i remove them?
@lyndzeevilla1710
Жыл бұрын
The head didn’t release for me? What did I do wrong?
@AprilD101
Жыл бұрын
Did you figure this out? I can't get mine to move either
@robbie1916
11 ай бұрын
Start process with printer switched on. Then remove the power cable at back whilst on and thereafter the head will move.
Пікірлер: 23