Good job using your bumper jack to grip onto the shaft
@danielploy9143
2 жыл бұрын
Get the new auger release fast acting gell.
@tonymoore6479
Жыл бұрын
Very helpful; Thank you
@stevek3627
3 жыл бұрын
Did you mean visegrips or channel locks?
@tazman572
3 жыл бұрын
He did say "channel locks" but did use "vice grips." I would guess that Vice Grips would be better as you can "lock" them on the auger shaft better than trying to hold the channel locks with your handgrip.
@hlurpseed
2 жыл бұрын
Thank you!!!
@dannyc7839
3 жыл бұрын
If my auger motor only spins sporadically does that mean it's bad? And I don't mean like timed spinning
@bradtroha9376
3 жыл бұрын
Mine doesn’t have an Allen bolt to remove the auger. It’s a pin with a ring on the end and it won’t budge… any ideas?
@PopdaddysBBQ
2 жыл бұрын
This company sends me the protypes to r and d. After you empty your hopper run the remainder through the pot until it stops. Otherwise in some climates.. it has the same effect as if you never emptied the hopper. This should be included in the video. I have a 7 vertical by pit boss that doesn't even have a serial number prototype and still runs and it is half the smoker these Traeger beauties are.
Пікірлер: 10