Get your new BIQU MicroProbe up and running with these simple instructions.
*************************************************************************
Affiliate links to help the channel grow.
BIQU MicroProbe -- shareasale.com/r.cfm?b=189092...
H2 V2S Lite Direct drive extruder -- shrsl.com/47lv7
BIQU/Bigtreetech Official sales site -- shareasale.com/r.cfm?b=189092...
*************************************************************************
If creating a separate .cfg file make sure to add the [Include name.cfg] in the printer.cfg file
In the video I show it as [include MicroProbe.cfg]
The following code can be copied and pasted into a new .cfg file, for example MiceoProbe.cfg. Make sure to edit the pins and coordinates to meet your machine's needs. the part that says HermitCrab: is there because I am referencing the pins on my Hermit Crab tool changer board. change or remove that if you have a different set-up.
[gcode_macro Probe_Deploy]
gcode:
SET_PIN PIN=probe_enable VALUE=1
[gcode_macro Probe_Stow]
gcode:
SET_PIN PIN=probe_enable VALUE=0
[output_pin probe_enable]
pin: HermitCrab:PB1 # Change this to the Servo/control pin number for your board.
value: 0
[probe]
pin: ^!HermitCrab:PB2 # Change this to the Probe/Z- pin number for your board. Remove the ! for V1 probes.
deactivate_on_each_sample: False
x_offset: -39.4 # Change the probe offsets to meet your machine requirements.
y_offset: -1.5
#z_offset: 1.460
speed: 5.0
samples: 2
#sample_retract_dist: 2.0
samples_tolerance: 0.05
samples_tolerance_retries: 3
activate_gcode:
Probe_Deploy
G4 P500
allow time for probe to deploy before homing Z
deactivate_gcode:
Probe_Stow
[bed_mesh]
speed: 150
horizontal_move_z: 5
#mesh_radius:
#mesh_origin:
mesh_min: 35, 6 # Change this is the coordinate for the first probe point
mesh_max: 180, 175 # Change this is the coordinate for the last probe point
probe_count: 5, 5
[safe_z_home]
home_xy_position: 145.6, 90 # Change this is the coordinate for the center of the bed
speed: 50.0
z_hop: 10
z_hop_speed: 15.0
[screws_tilt_adjust]
Set your own coordinates to position the probe over the screw points.
screw1: 30,30
screw1_name: Left-Front
screw2: 190, 30
screw2_name: Right-Front
screw3: 190, 170
screw3_name: Right-Back
screw4: 30, 170
screw4_name: Left-Back
speed: 100
horizontal_move_z: 5
screw_thread: CW-M3
Негізгі бет Ғылым және технология How to configure the BIQU Microprobe for Klipper
Пікірлер: 122