I want to apply strain gauges to the beaks of plier , which size of strain gauges should i apply and whag thickness
@RichPedro
4 жыл бұрын
Can you demo setting up a DP25B-S strain meter and a compression load cell ?? (I have an LC302-100). Do I need a calibration shunt to do the set up??
@laithsabahmohammed6564
5 жыл бұрын
Hi. I want to measure micro strain for carbon steel (mild steel) size (200mm×100mm×10mm) by using one strain gauge only in one direction ( force in the end ((bend)). I hope you will help me to find the right device and the suitable strain gauge 120 or 350 .
@bijanjahanara465
3 жыл бұрын
Is it possible to use 3 wire strain gauge at quarter bridge configuration by Omega BCM-1 bridge completion module ? If yes , what is its wiring ?
@DwyerOmega
3 жыл бұрын
Hello Bijan, We would love to assist you with your setup - please email: pressure@omega.com
@viveharc
3 жыл бұрын
hi thanks for the info , could u pls show the SGT-3FS /350-SY11
@JZ-Sensor
6 ай бұрын
I got it.
@thirukrishnan9292
5 жыл бұрын
how do you do the calibration on a rounded shaft ??
@minhtrieu5725
3 жыл бұрын
Could you show how to connect BCM-1 to iNet-512? Thanks
@DwyerOmega
3 жыл бұрын
Hello Minh, thanks for your question! Here is a link to see wiring for a full bridge to the INET-512: www.instrunet.com/usb_data_acquisition/connect_to_windows_computer/strain_gage/strain_gage_usb_data_acquisition.html For more information please email das@omega.com or call 1800 622 2378 I hope that helps.
@torpedo0101
4 жыл бұрын
next time paste the strain gauges next to the clamp where the momentum is maximum...
Пікірлер: 14