I LOVE SPELLBINDERS DIES, THIS WAS MY FIRST SET. WHAT YOU ARE USING.
@maryegloff187
5 жыл бұрын
Can you tell me, if you know what die set would cut the main layers out that you are showing, instead of using a trimmer? A die cut set with the three layers - 4.25x5.5, 4x5.25,
@crafting4fun247
5 жыл бұрын
I have not seen a set that specifically advertises that it will cut the layers for a standard A2 sized card ( 4 1/4 x 5 1/2, 4 x 5 1/4, 3 3/4 x 5 ......) I have several die sets that do some but not all of these sizes. Please let me know if you find a set like this.
@MoMaryR
6 жыл бұрын
So you don't actually cut on the magnetic platform? you are putting another plate on top and it still is magnetic through the extra clear plastic layer?
@vickiecrawford3357
6 жыл бұрын
I do not cut on my mag Eric platform directly as this will damage the surface. Put a clear acrylic plate on top. The magnet is very strong and will still hold dies in place. Them add your paper and die and cover with another acrylic plate. This sandwich will cut nicely and keep your magnetic plate in good condition. :-)
@vickiecrawford3357
6 жыл бұрын
Sorry I did not spell magnetic correctly. A bumpy road and fat fingers! Lok
@MoMaryR
6 жыл бұрын
Many thanks
@livethegoodlife1740
8 жыл бұрын
I USE A MAGNETIC SHIM HOMEMADE..
@crafting4fun247
8 жыл бұрын
+LIVE THE GOOD LIFE I used a Magnetic Platform and my two clear acrylic cutting plates. I didn't find that I needed a shim. I understand that all Big Shot machines vary slightly so your's may require a shim. FYI, I love both the Sizzix Magnetic Platform and the Sizzix Precision Base Plate These accessories make it so much easier to get clean, precise cuts.
Пікірлер: 10