Subscribe - goo.gl/iAwSQc
NOTE: This method is neither intended nor recommended for prescription or corrective lenses! This was easier than expected and since I had lenses on hand that were large enough, it went a lot faster than bringing them in and having an optician order new lenses and perform a custom cut for these frames. I liked these Prada VPR 23R frames from when I wore prescription eyeglasses so after getting Lasik surgery, I decided to use them as sunglasses. As a recovery diver, I have a lot of sunglasses that I've pulled off the bottom to use as lens donors but I wouldn't hesitate to buy an inexpensive pair of sunglasses to get the right donor lenses. Either way, just pick a pair with lenses large enough and then custom cut them as shown in the video. It was easy, fast and worked out well.
To Get the Job Done:
-The sander in the video: amzn.to/2XV1znz
-A cheaper sander: amzn.to/33TlHKJ
-Assorted sand paper: amzn.to/3kYjank
-80 Grit Only Sandpaper: amzn.to/2DMopai
-Tape to protect lenses: amzn.to/3kDpWju
PROTECTIVE GEAR:
-Face Masks: amzn.to/3D0zCiW
-Safety Goggles: amzn.to/3fZQfNq
-Safety Goggles (2-Pack): amzn.to/2PX2eR5
-Ear Protection Ear Muffs: amzn.to/3QOBMrq
-Ear Plugs: amzn.to/3CZJHfR
-Shop Gloves: amzn.to/3aGzAgV
-Nitrile Gloves (6-mil): amzn.to/3awjyWQ
Video Index:
0:05 The Frames I want to Use
0:20 Selecting the Donor Lenses
0:40 Removing Existing lenses
0:53 Apply Protective Tape to Donor Lenses
1:40 Tracing the Donor Lens
2:38 The Sander and Sand Paper
3:08 Sanding By hand
3:35 The 45 Degree Edge
4:20 Remove the Protective Tape
→ Become a ScubaMoto Subscriber - goo.gl/iAwSQc
→ If this video helped, please give a thumbs up and subscribe for future videos
→ As an Amazon Associate I earn from qualifying purchases at no extra cost to you. Win!
→ Business Inquiries email: scubamoto@outlook.com
Негізгі бет How To Cut Lenses to Fit Your Frames
Пікірлер: 120