Very informative sharing, please continue to post such content!
@pinoyseamakinista12
2 жыл бұрын
Sure thank u
@JB23VLOG
3 ай бұрын
Thank you for sharing Sir..
@renzandjmschannel
2 жыл бұрын
Nice video
@jeanpaulletada2969
4 ай бұрын
thanks and thanks sir! nice video and kindly post more videos
@pinoyseamakinista12
2 ай бұрын
I will try my best
@shawncalva2676
2 жыл бұрын
idol🙌
@kiberkiber4792
4 ай бұрын
Thanks 👌
@makinistangmandaragattv5560
2 жыл бұрын
Very informative chief...pa shout-out po
@pinoyseamakinista12
2 жыл бұрын
Sure sir di pa nkapag edit ng vids nxt vids nlang sir
@soldierking6901
2 жыл бұрын
Sir why didn't you limit the rpm and load settings in chief limiter during cut off? What about the exhaust valve operation ?
@pinoyseamakinista12
2 жыл бұрын
The maker sent us the max rpm and the cut off cyl exhaust valve operation is in normal operation
@zakt3813
2 жыл бұрын
Should we keep the exhaust vv of that unit in open position in this case chief?
@pinoyseamakinista12
2 жыл бұрын
the exhaust valve is still working only the cooling water and fuel should be closed in that cylinder and lubrication is set to minimum.
@bhaskarnathani9535
2 жыл бұрын
Can you tell cutt off procedure for an mc or an mcc engine as well?
@pinoyseamakinista12
2 жыл бұрын
i did not experience it yet but i try my best to share it with u guys
@sailorlifeisbeautiful6180
2 жыл бұрын
👍
@gapzmack7572
Жыл бұрын
Sir may i ask if ME was at stop condition? Many thanks
@pinoyseamakinista12
Жыл бұрын
At the time we cut-off the malfaction cylinder it was in stop condition coz we neet to stop it due to lack cooling water system
@pinoyseamakinista12
Жыл бұрын
As far as i know it ahould be in stop condtion
@pinoyseamakinista12
Жыл бұрын
Yes it should be in stop condition
@ranulfotubog3357
2 жыл бұрын
I think the main engine is MC-C ang procedure nang pag cut off, ay for mc-c, ty
@pinoyseamakinista12
2 жыл бұрын
It's ME sir
@hayatokazami9214
2 жыл бұрын
Good day po sir tanung ko po kung manbw mc po ung main engine anu po ung mga procedure para icut off ung isang cylinder po salamat po sa pagsagot
@pinoyseamakinista12
2 жыл бұрын
different ang procedures at complicated not experience that trouble yet but we' ll do it soon
@igormatisorovic52
Жыл бұрын
You have on VIT small actuator and there you can cut off one cylinder....and Engine dont need to be in stopped condition,only slow down on Dead Slow and you can cut off one cylinder.
@pinoyseamakinista12
Жыл бұрын
In our case sir we need to stop immediately due to no cooling the breakage is very large and need to stop
Пікірлер: 27