VERY useful info.! Thanka for taking the time to make a video on how to de-assist and remove the safety on a 581 Barrage. I think I'm going to remove the safety feature first. Thanks again!
@repeatdefender6032
8 жыл бұрын
this is the only video I can find that shows this, thank you!
@Antimonyish
8 жыл бұрын
Just FYI you can take the spring out without having to remove the G10 scales. All you need to do is get to both sides of the pivot and remove the casing(it takes a bit of tweaking) and you're done, assembly is even easier than on a non assist knife.
@richard-mai
7 жыл бұрын
Can the safety switch along the spine be left in and function normally without the spring assist? Thank you
@shcmoly
7 жыл бұрын
It does on the Emissary.
@channel3161
11 жыл бұрын
The problem I can't seen to overcome is when,all said and done the blade is not centered at all! It runs really bad INS the ball/spring side of the liner. Help!
@jeremyburris4890
6 жыл бұрын
Sorry nobody helped you. How did it turn out?
@SharpThinkingKnives
6 жыл бұрын
Sorry man I lost the channel years ago. Forgot my login.. many assisted knives aren't centered after having been deassisted. I have the same issue with mine.
@-tzadakim-7805
2 жыл бұрын
Who’s stupid idea was it to make a benchmade knife assisted?
@adammaultasch6833
7 жыл бұрын
I have a 470 emissary. Do you think it works the same to deasist it ? I would like to do the same with it.
@dannyspontan4915
3 жыл бұрын
Should have left it as is from the factory.Why would anyone buy a assisted knife and then remove the assist?
@bohakkennes1288
3 жыл бұрын
Because you wanna close it one handed
@rekozma
6 жыл бұрын
Question? Why. It's a $205 Benchmade that works great they way they made it. Why take the assist out? It's one of the only assist knives I own that I actually like.
@SharpThinkingKnives
6 жыл бұрын
Sorry I lost this channel years ago, I just dont care for it $200 or not.
@elijahadamson5906
5 жыл бұрын
because is some places it's illegal to have a spring assist, but it is legal if you remove the assist
@jeremyburris4890
6 жыл бұрын
Not worth it. My knife is garbage now.
@SharpThinkingKnives
6 жыл бұрын
Not worth what?
@jeremyburris4890
6 жыл бұрын
Taking it apart
@SharpThinkingKnives
6 жыл бұрын
@@jeremyburris4890 I made this video years ago and I've done it to 4 other knives without any problems. Sometimes benchmade tolerances aren't the best though... one of my zt 0350s I reassisted because it didnt have a good enough detent.
@SharpThinkingKnives
6 жыл бұрын
@@jeremyburris4890 I'll admit this video sucked as well 😂
@jeremyburris4890
6 жыл бұрын
The video was fine, I got all the info I needed. I guess I just don't have the skill or patience to adjust the pivot properly. I sent it to benchmade and they fixed it.
Пікірлер: 23