Y’all should know better than to show the clutch setting being adjusted as you say to place the drill in a low speed setting.
@CurvedSlightly
5 жыл бұрын
Sorry, I'm looking for a drill that is 44% quicker.
@nunyabidnis5407
2 ай бұрын
I would put my thumb against the bit, position it and rock the drill without the bit spinning. This would put a small divot in the glass so the bit wouldn't go all over the place.
@umerfarooqfarooq3210
6 жыл бұрын
Use water
@commiato
4 жыл бұрын
You showed the clutch not the speed being moved.
@TallontedTinkering
3 жыл бұрын
That cracked me up to... I had to rewind it to make sure I wasn't seeing things.
@stevelaminack1516
5 жыл бұрын
Are these sold anywhere in the US?
@broniusl.4227
3 жыл бұрын
Rubbish drill bit
@1demboyz402
9 ай бұрын
Ty for explaining
@jairpflgafe7419
5 жыл бұрын
Tengo que hacer 200 agujeros
@grishagregorian5517
Жыл бұрын
Good info.
@Charita8
2 жыл бұрын
Thank you!
@sonakshidancechanel2018
2 жыл бұрын
Nice
@rafaelramos1486
4 жыл бұрын
thanks
@hashtastic3537
6 жыл бұрын
And it only takes an hour and a half to drill a single hole!
@Glorytranthi
6 жыл бұрын
Hashtastic may you advise me the drill bit for drogue hole with diameter 2.2mm?
Пікірлер: 18