In this video I show you how to drill the end of a round bar / rods / round stock without a lathe. This method works well for long pieces of round stock that will not work with other methods I've seen here on KZitem. You will need a drill press to achieve this center drilled hole.
Check out some of the suggested materials below. As an Amazon Associate I may earn a small commission (at no extra cost to you)
- Spare Drill Chuck: amzn.to/4eprSqY
- Plumb Bob: amzn.to/4d6oAHX
- Magnetic Protractor: amzn.to/3Tx9x3c
- Bubble Level: amzn.to/3TzdCUC
- Center Punch: amzn.to/3XLTSzr
- Center Drill: amzn.to/3XL3KJY
- C Channel
- Nuts and Bolts
- Nozzle or something similar
Please comment below with suggestions to improve this design. This is not intended to replace a lathe...
****************************************************************
If you enjoy and have benefited from my content and are feeling generous I would love your support! You can "buy me a coffee" here:
► www.paypal.com... ☕
By supporting my channel you are encouraging me to continue with this time consuming endeavor. A lot of time goes into design work, building my projects, filming the videos, editing the videos, etc. Plus it all costs money! Your generosity goes a long way in helping me bring you better content as often as I can!
Follow me on Instagram!
► / embraceracing 📷
If you liked this video, perhaps you will also enjoy some channels that I personally find inspiring and interesting...
DIY and MAKER:
► The Hacksmith
/ @hacksmith
► Adam Savage Tested
/ @tested
► Thomas Sanladerer
/ thomassanladerer
Car Content:
► Mighty Car Mods
/ @mightycarmods
► Drivetribe
/ @drivetribe
#fabrication #tools
Негізгі бет How To End Drill Round Stock (Long Rods Without a Lathe!)
Пікірлер: 55