Get my custom pipe invert tags and spot elevations at the link below: www.mepguy.com/offers/jqgpoE8Y
@jondepaul2372
Жыл бұрын
Your content is top notch, thank you. Pipe invert elevation is the lowest point of the inside diameter. Pipe invert elevation is the elevation of the inside bottom of the pipe. You can see the value listed @6:25 under Constraints parameters. Lower End Invert Elevation = (-3.064).
@mep_guy
Жыл бұрын
Thanks so much Jon. I realize that now after making the video. Appreciate the feedback!
@mikemccall169
Жыл бұрын
I have been waiting for some more content. Thanks for sharing
@mep_guy
Жыл бұрын
I know! It's been a while... I'll be adding some more good stuff in the near future!
@JohnNeves
Жыл бұрын
Great content. Turning down music volume will make it even better.
@mep_guy
Жыл бұрын
I'll consider it!
@jayblake682
Жыл бұрын
Great video. Nice catch on the grease waste slope. One question, though. On the invert out, it was -10.69’, but the spot elevation gave it as 90.32’. Shouldn’t the actual elevation have been 89.31’? I think the spot elevation was grabbing the wrong data. At least I think it was.
@Ryan-zk2jq
Жыл бұрын
Honestly, I think it might have been grabbing the wrong piece of data. There are two similar invert parameters, and I do think I might have been using the wrong one. I think I noticed it later on and made sure to fix it but I decided it was not that big of a deal. But glad you are paying attention haha! I have a little mini course where I explain how I built these tags available on my website.
@jayblake682
Жыл бұрын
@@Ryan-zk2jq that was my thought as well that it was grabbing the wrong data
Пікірлер: 14