The good: spark plug removal, spraying lube in cylinders. Your patience. Your good luck in getting it running. The bad: This is a text book way to burn out a starter. Between 1:40 and 2:17 you rotated the crank but the water pump pulley did not rotate. This proves either the water pump pulley (top center) or power steering (?) top right were seized. It is always best to remove the accessory belts, free up the cylinders and valves first, then reintroduce 1 belt at a time to minimize the load on the starter or breaker bar (crank bolt).
@DoAnythingNew
Жыл бұрын
Hey there.. I just bought a 1980 Tahiti Day Cruiser with the same mercury 5.7 260 and it sat for 6 years.. so I’ve been watching these videos before I even begin to attempt it. Any way of contacting you so I can get some ideas and steps? Your observations on removing the belts alone are invaluable. Don’t want to miss something before I try it.
@DoAnythingNew
Жыл бұрын
Thank you!!!’ I just bought a 1980 Tahiti Day Cruiser.. with the same engine and it sat for 6 years! I have no idea if it’s frozen but after this video I’m so ready to tackle it! Thank you!
@sostanza3
Жыл бұрын
My 7 year-old son and I enjoyed watching you guys get this started👏👏👏👍!
@ROBERT75528
4 ай бұрын
Nå początek wykręć świece wprowac do cylindrów środek na bazie oleju smarowania i rozpuszczania nagaru i rdzy. Potem delikatnie poruszać wałem specjalnym kluczem po zdjęciu koła napędowego paska. A sstepnie kręcisz rozrusznikiem po odklejeni pierścieni od cylindrów. Sprawdzasz iskre świeże paliwo i powinien zapalić. 💪👍🔥
@arieloflameusa
2 жыл бұрын
Dobra robota panowie
@RetroComandante
6 ай бұрын
Ok, I'm struggling with this same issue. Where did the dirty water come out from? The spark plug wells? I'm looking to possibly replicate this
@koyaanisqatsi316
11 ай бұрын
The big issue with a seized boot engine is that there is a great chance the engine is cracked on the inside (freeze damage). If you're lucky then it's only a bad gasket from the intake manifold. Both can be repaired but the block being seized is probably not your only problem.
@timothyallbritton1961
10 ай бұрын
I can see that this was two years ago and everyone has to learn, but this was painful to watch...
@vetlebuom7352
10 ай бұрын
I just bought a renken spitfire v8 and it wont start, the last owner had its sitting in a warehouse for 2 years. I have not yet found the courage to even touch it and I don't know what to do, mind giving some tips?
@inquisitive980
7 ай бұрын
No WD 40 Use graphite penetrating oil
@damienjohnson7582
Ай бұрын
Only in absolute emergency. That hurt
@user-id8dq3ix8u
19 күн бұрын
Take plugs out bro. And spray insidethere after letting sitting ur fighting everything
@user-id8dq3ix8u
19 күн бұрын
Ah they wasss. Dammmmm that was rough
@Alex-en4bd
11 ай бұрын
What are you putting liquid wrench in the air intake ? Just asking I thought it goes in the cylinder
@lastchanceshop
11 ай бұрын
To help lubricate all cylinders it's run tru intake manifold and cylinders
@roymeier6893
2 жыл бұрын
Hi great job getting it going. How long was the engine sitting to get sized like that? I have same issue I am sure
@lastchanceshop
2 жыл бұрын
Around 4 years
@evanbushong4291
2 жыл бұрын
I hope mine does this did you soak the cylinder heads in anything?
@lastchanceshop
2 жыл бұрын
No just put diesel fuel or penetration fluid it will be fine
@jdmforever5583
Жыл бұрын
Good way of burning out your starter
@buffordevans6942
Жыл бұрын
The bolt to my crank has been rounded and I cannot get a socket on it 🙃
@evanbushong4291
2 жыл бұрын
Did you put that washer on crank bolt?
@lastchanceshop
2 жыл бұрын
What are you mean by that
@904will
2 жыл бұрын
I have the same issue
@bxbmbr766
Жыл бұрын
Does this work with a mercruiser 3.0L
@lastchanceshop
Жыл бұрын
I don't know but is worth to try
@johnathanpeyton
11 ай бұрын
Better to remove the plugs put oil in the cylinders and rock the engine back-and-forth by hand with a socket wrench instead of trying to fry the starter
@justinsideyou8763
Жыл бұрын
what motor is this cause i just bought a boat and i cant identify the motor yet, but this one seems to be very similar
@lastchanceshop
Жыл бұрын
This is 5.7 MerCruiser
@evanbushong4291
2 жыл бұрын
Did you have water in engine? If so where do you think it came from
@joanquito9382
2 жыл бұрын
We’re you able to find a solution i hve the same issue
@znaszgoprzeciez2229
2 жыл бұрын
Dobra jest
@904will
2 жыл бұрын
Are you in Florida if so could you help me
@lastchanceshop
2 жыл бұрын
Sorry I'm in PA
@ericneering6357
Ай бұрын
I’m not even a mechanic and I know this is wrong. Get a big breaker bar and put it on the front and turn it over by hand.
@andrewhirtle3525
Жыл бұрын
Lol 😂
@deksea
8 ай бұрын
Dont want to sound too harsh, but you really have no idea what you're doing, and some of what you did was very dangerous.
Пікірлер: 39