Very thorough, step-by step. Good commentary. I would use a rubber, hard plastic or brass hammer to hit and drive stuff out, but that's just me. Put the valve in a drill and spin it to see if it's bent. Lay the push rod on a flat surface and roll it to see if it's bent. Good to mention to NEVER start nuts and bolts with the impact unless you want to deal with cross-threaded problems. Good to see how the head and valves are easy to work on.
@krkmofet4189
4 ай бұрын
Awesome explanation. Im going through something like that. What a job. Thank you for furthering human existence.
@bryanpryorpryor6172
28 күн бұрын
Would have liked to see the whole rocker arm and push rod complete with valve ajustment
@creepycrawler4690
Ай бұрын
Would this cause low compression?
@robertmailhos8159
11 ай бұрын
The mic is working just fine there repair gang
@RepairGang
11 ай бұрын
Thank you
@robertmailhos8159
11 ай бұрын
@@RepairGang your welcome repair gang 👍
@morrismutugiMuriungi
8 ай бұрын
What causes generator to stop working and kick harder
@RepairGang
7 ай бұрын
Valves
@headpainter1
11 ай бұрын
That valve had to be bent.
@RepairGang
11 ай бұрын
It was
@thelordwaffles8
2 ай бұрын
Thanks for teaching me, so I may now teach my children. Hope you’re doing well
Пікірлер: 12