Year 2024 Update. Yes, I still make these. To Purchase Email me with your Car year, make, model and trim to: diycarmodify@gmail.com or contact me through any of my social media account Diycarmodz
Plug and Play Turn Signal LED Resistor Wire Harness Product Update Installation and Demo
How to install plug and play led resistor kit. Load resistor to fix turn signal hyper flash.
Hyperflashing issue: 3:33
Hyperflash Fix: 1:19
Termperature reading: 4:30
This is used to fix hyperflashing turn signal when installing turn signal bulb.
Now available, Plug and Play turn signal resistor harness to fix rapid turn signal hyperflashing:
Acura ILX
Acura MDX
Acura RDX
Acura TL
Honda Accord
Honda Civic
Honda Crosstour (2010+)
Honda CR-V
Honda Fit
Honda HR-V
Honda Odyssey
Honda Pilot
Honda Ridgeline
Lexus 350
Lexus 200h
Lexus is300
Mazda 3
Mazda 6
Mazda CX-5
Mitsubishi Galant
Nissan Sentra
Nissan Xterra
Toyota 4runner
Toyota Camry
Toyota Corolla
Toyota FJ Cruiser
Toyota Highlander
Toyota Prius
Toyota Rav4
Toyota Sequoia
Toyota Sienna
Toyota Solara
Toyota Tacoma
Toyota Tundra
Toyota Venza
Toyota Yaris
Toyota Yaris iA
Toyota Land Cruiser
If you would like to purchase a set, please send an email to: diycarmodify@gmail.com
Welcome to another episode of DiyCarModz. I’m Jeff and in this video I will demonstrate how to install the new updated Plug and play turn signal led load resistors version 5.0.
These Plug and Play LED turn signal resistor wire harness are made using socket and plugs that are 100% direct fit. No splicing, No cutting and modification are required. Wires are color matched to OEM wire color scheme, soldered, heat shrink wrapped and wire loomed for clean and professional appearance. Very easy to install, and remove to go back to stock. NO TOOLS REQUIRED.
In order to fix the hyper blinking hyperflashing turn signal rate to normal rate you have to either replace the flasher relay to an electronic led flasher unit or have to install resistors. In the past, you simple had access to the flasher signal relay. However on the newer vehicles the turn signal rate is controlled by the BCM and therefore it is no longer a simple relay swap. You HAVE to install resistors no way around it.
Q&A:
Q: Do I need to install led on both the front and rear for the resistor harness to work?
A: No, this will work with just the front turn signal switched to led or rear turn signal bulb to led or both front and rear to led. You just need to install it on the rear or the front turn signal wire harness. (depends on vehicle)
Q: Do I need to install one per each turn signal socket?
A: No, just the rear or front turn signal wire harness. One on the driver side and one on the passenger side.
I can be reached via:
👉Facebook: / diycarmodz
👉Instagram: / diycarmodz
👉Email: diycarmodify@gmail.com
👉Mailing Address:
DIYCarModz
9051 Mira Mesa Blvd
Unit 262321
San Diego, CA 92196
2013 2014 2015 2016 2017 Honda Accord Sedan and Coupe Upgrade to Touring Headlights. You need to this fix the hyperflashing issue on the Touring Headlights.
#hyperflashing #turnsignal #resistor #hyperflash
Негізгі бет Автокөліктер мен көлік құралдары How to fix hyperflashing turn signal led. Plug and Play Resistor Kit for Honda, Toyota and Mazda
Пікірлер: 269