You were correct, the cold air was coming in from outside through the ventilation hose because the vent flapper was stuck open. Very helpful, thanks!
@sophiaalvarado5995
5 ай бұрын
Do you no the part number to the sensor
@mohnewyork1082
Жыл бұрын
I had the same problem with my customer
@purifiedwater16.9oz4
Жыл бұрын
Where do you purchase the thermostat? LG or any local supplier ?
@hameedwafaAFG
Жыл бұрын
Yes lg or appliances parts source
@purifiedwater16.9oz4
Жыл бұрын
@@hameedwafaAFG I replaced the thermistor and I’m still getting this error and I tried starting it multiple times to get it to reset Any other suggestions?
@hameedwafaAFG
Жыл бұрын
@@purifiedwater16.9oz4 if you replaced your thermistor the next part is main control board nothing else .
@purifiedwater16.9oz4
Жыл бұрын
@@hameedwafaAFG okay that’s an expensive part I saw . The dryer is only 4 years . Is this a common problem with LG gas dryers ?
@hameedwafaAFG
Жыл бұрын
@@purifiedwater16.9oz4 not really usually ventilation problem causes this issue .
@evaristoaguilar8201
7 ай бұрын
YA CAMBIE EL TERMISTOR HICE EL RESET Y SIGUE MARCANDO TE1
@migdaliarivera-alejandro8479
Ай бұрын
Lo arreglaste? Tengo la misma problema con mía.
@diegoflash11
Жыл бұрын
I replaced the thermistor and I keep getting the same code, I bridge the connector just to test it and runs fine, if leave on like that that could be a fire hazard, when I connect to the thermistor it keeps giving me that code and does not run at all, what else should I look for?
@hameedwafaAFG
Жыл бұрын
Sorry for late reply. If you replaced thermistor and still had problem, it’s most likely the main relay board nothing else .
@diegoflash11
Жыл бұрын
thank you for your reply, I will keep this knowledge for future possibly repairs, and yes you are right the bord was not good, but customer decided to buy a new dryer.
Пікірлер: 24