After replacing a dead battery in my Mitutoyo calipers, with a fresh new good quality battery - amzn.to/2LpK6Rn - the display started flashing with dashes, and no amount of button pressing would make it go away. I had to do a little research to find out that the way to get rid of the dashes is to do a hard reset.
Push the ORIGIN button and hold it for more than one second, until the flashing dashes disappear, and the screen shows a normal reading. Then the Mitutoyo calipers will operate normally again.
Buy only good quality replacement #357/303 (Sr44sw) watch batteries - amzn.to/2LpK6Rn
Buy the 6" Mitutoyo Calipers here - amzn.to/3txy8q8
Buy the 8" Mitutoyo Calipers here - amzn.to/39VilJC
How to Fix Mitutoyo Calipers Dashes Flashing on Display
#calipers #mitutoyo #engineer #measurement
The products shown here were purchased by me with the intent to use them. I did not receive any free items, and I am not being paid or compensated for this review. The video and description may contain affiliate links. If you click on a link, I may receive a commission. Money earned helps to support my channel and bring you more informative videos about engineering, crafting, and DIY.
Негізгі бет Тәжірибелік нұсқаулар және стиль How to Fix Mitutoyo Calipers Dashes Flashing on Display After Replacing Batteries | Digimatic
Пікірлер: 227