anyone getting ready to do this job, needs to read this first. ignore taking everything apart inside the truck. all you have to do is get a long 24" big screwdriver and push up on the old vent then gently pry the bottom snaps out and pull the old vent off. if you worry about the paint just wrap the screwdriver with tape. slide the new vent up into place using screwdriver to be sure the top end snap is in first, then snap in the bottom by pushing it in. it is not hard to do at all and i was able to do both of my vents in 5 minutes from start to finish.
@tjeffers99
5 жыл бұрын
I have a 2006 GMC Sierra and I am having the same issue. I haven’t repaired mine yet but this video certainly helped me think through the process. I appreciate you posting this....hopefully mine will be this easy.
@tleb8111
Жыл бұрын
I seen a KZitem video of a guy replace them from the out side.kzitem.info/news/bejne/oqCJ0o6gcHV4lI4
@whodat5953
5 жыл бұрын
For a 2007 GMC Sierra 1500 single cab new body style they cost $27 I just found out today I have to replace mine after a heavy rain my cab had a lot of water in it at first I thought it was the seals around the door or maybe the light as you said on top but after doing a few tests with a gallon of water pouring it over the top to find out where the leak was coming from it came from each one of my vents so I found this video very helpful I appreciate your help for posting this video it's going to save me a lot of money with labor
@chevygmz
5 жыл бұрын
william larson Glad it helped brother. I could not find anything on this so i figured id record it and post it. Be blessed.
@StockDude
5 жыл бұрын
Man, what a pain it was for me to finally figure out where my leak was! Like you said at the beginning, i thought it was the cabin light gasket, so I replaced that, but then it continued to leak and shorted out my amp mounted behind my seat! It continued to leak, so I even siliconed around that light and even the rear window thinking it was leaking in through those spots. The leak continued. What a pain. So I finally realized it has to be these cabin vents which i then siliconed on the outside between the cab and bed, as a temporary measure! I had to attach a clear tube to a caulk tube to be able to get the silicone between the cab and bed. What a pain. That stopped the leak. I have now ordered two new vents. Cheap like you say. But i just don't see how these things keep water from getting in the truck. But anyway, the whole idea of the vents is to protect occupants from toxic fumes that could develop in the cab, but if they start letting in toxic fumes when they fail, what's the point of them? I almost wish I could plug those holes up permanently. Thanks for the video.
@littlejay2o02
5 жыл бұрын
I'll be going home at lunch to poor some water on this. After months of looking and getting told it's the door seals or brake light, this looks promising!
@frankmtz7007
4 жыл бұрын
Thanks sharing, this helped me figure out how to replace the vents on my 2005 GMC Sierra. And you are right, I first thought it was my 3rd brake light, which I first replaced the seal on.
@findingneutral
2 жыл бұрын
Great tutorial. Much appreciated. I have a 2002 GMC Sierra and had no clue about these. Thanks
@oleole2053
3 жыл бұрын
Good video saves me a lot of time for my 2004 Chevy Colorado!! just remember to take care of the rust with sand paper and joint sealer and a little paint.. ;)
@auzzy89
5 жыл бұрын
Thanks man, I was missing most of the rubber covers on mine. You saved me a ton of time. Merry Christmas.
@chevygmz
5 жыл бұрын
Austin Howard I am glad it did. Merry Christmas and God bless you
@lolmandood
2 жыл бұрын
Thank you so so much for this video. Exactly what I was looking for. 👍👍. Mine has the same leaking issue. Mold started to grow.
@ComeAtMe
7 жыл бұрын
Thanks alot no more annoying wind noise in the cab.
@Twigggggy
7 жыл бұрын
Thanks for the part number that is really helpful.
@chevygmz
7 жыл бұрын
Good luck with your leak hunt. Besides the rear/third taillight or those vents. I do not knot what else it could be.
@StockDude
5 жыл бұрын
Well, like I said in a previous post, I also thought it was my rear window gasket. So I put silicon outside to seal around the rear window. But that's not what it was.
@dougsmith747
Жыл бұрын
Great video! Thanks for sharing! Did this stop your water intrusion?
@joedurso5192
2 жыл бұрын
So you have to remove the vent before pulling the inner black snorkel piece? I know you can replace it start to finish from the outside without removing anything inside but I have the inside all undressed to help dry things out and I want to clean the cab face real good before installing the new vent and the easiest way is through the inside once that black inner vent/snorkel piece is removed. Thanks Man…!!!
@ryanerb403
7 жыл бұрын
Thank you! Your video helped me!!! THANK YOU!
@edgmz3951
7 жыл бұрын
awesome to hear that it did.
@mikestallworth945
5 жыл бұрын
i did this from the outside with a long flat head. took 10 minutes.
@chevyvantravel9735
7 жыл бұрын
i have the same problem i get water on the plastic cover so i m going to check out the light tomorrow and if its not that then i ll do the vents...
@viivcreations9161
5 жыл бұрын
and yes these vents are important for air pressure regulation. when you close your refrigerator and it don't have a vent it then draws vacuum and makes it very hard to open. But if it had a vent it allows the air to pressurize back to normal and allow it to open easily with no vacuum. These do the same thing. But since you will be in the vehicle it can pop your ears harshly the harder you slam the doors, vehicles arnt air tight so it will eventually just re pressurize through cracks and such.
@stevenwillard2285
7 жыл бұрын
I have an 06 Silverado and thought it was my 3rd light messing up as well, definitely not my vents though. Seems to be coming from the window itself.
@edgmz3951
6 жыл бұрын
Althought rare. The silicone glue can dryrot/crack and allow water in. I think you are correct.
@esojossaj1627
6 жыл бұрын
I just woke up from a raining night and it seems I have the same problem with my 2006 silvarado what do you recommend
@jasonbrittingham655
Жыл бұрын
Was under your carpet insulation wet too. If so how did you dry it
@evilgenius3399
6 жыл бұрын
Do you have to take everything in the back off the interior if the vent is missing from the outside?
@jamestracy1077
8 жыл бұрын
Hey what's up man where did you get the replacement vents from? I'm having trouble finding them. Thanks
@chevygmz
7 жыл бұрын
search for: Chevrolet Silverado Pressure valve or Pressure vent
@ryanerb403
7 жыл бұрын
I bought mine from eBay. or the GMC / Chevy dealer!
@whodat5953
5 жыл бұрын
I had to buy mine from a body shop because no Standard Auto Parts store carries anything like this such as O'Reilly's or Advance Auto Parts
@viivcreations9161
5 жыл бұрын
Also, these are called Pressure Relief Valves. Not vents
@cesarhernandez8302
7 жыл бұрын
What happens if I just remove the black plastic piece but leave the vent there? Was Thinking about taking it out for more room for a subwoofer box
@edgmz3951
6 жыл бұрын
You need that vent there. Depresurizes cab when you close your doors. And allows air out when ac is set to pull air from outside instead of recirculating it. Aldo this keeps road noise out and keeps exhaust fumes out.
@shadowopsairman1583
3 жыл бұрын
A 1997 cab doesn't have these, GM should stop using them. I'd have 2 plates welded in to close that hole indefinitely.
@xcompa77x
7 жыл бұрын
do you know if this applies to extended cab as well? or just the crew cab like yours? also, how do i check if its the third brake light that is causing the leak?
@edgmz3951
6 жыл бұрын
Vents are the same for extended cabs. My best guess would be that your ceiling would be wet also.
@xcompa77x
6 жыл бұрын
thanks buddy, it actually was just the vents and not the brake light. almost went crazy looking for the source and nearly decided to tear apart my interior ha ha
@edgmz3951
6 жыл бұрын
Im glad it worked out for you.
@chrisyarber3352
7 жыл бұрын
What do these vents do
@bigcurt011
7 жыл бұрын
Chris Yarber these vents are very important they are designed to keep the cabin air tight which means no carbon monoxide poisoning will happen or if its hot outside and you have the windows closed pressure builds up and it has to escape somewhere
@danceswithjunk
5 жыл бұрын
let the rain in
@hunterkennedy150
3 жыл бұрын
What’s the part number?
@domino-ve6ei
3 жыл бұрын
@@str8chevys913 I Have 15268615 How ever its a discontinued part from what I hear.
Пікірлер: 52