Looking for a harness bar or even better roll cage for a 2014 mini coupe(r58) any recommendations you might have ??? Love the channel your passion and sharing skills are amazing thanks !!!
@guyonkeys
4 жыл бұрын
If you are in the UK, I can highly recommend Lohen (www.Lohen.co.uk) If you’re in other parts of the world, take a look anyway and look at the goodies we can get our hands on!!!
@big_bang_rrr1_evol0821
3 жыл бұрын
Hello, this is Korea.I always enjoy watching KZitem.I'm driving the n14.r56s. Currently, TurboMani+Downpipe+Capacity Intercooler has been worked. Manic Stage 2 is possible? I would appreciate it if you could tell me the settings needed for Manic Stage 2.
@ProjectMini
3 жыл бұрын
I don’t know the requirements for Manic but i don’t recommend Manic either
@NatedoGP
2 жыл бұрын
@@ProjectMini why not?
@boblabastida5171
4 жыл бұрын
I have a RPM Power Stage 2 tune on my 08 R55. I am installing the Snow Performance Stage 2 methanol kit. Should I expect an increase of horsepower without changing the RPM Stage 2 tune? And if so how much. Thanks for all the info.
@ProjectMini
4 жыл бұрын
You should expect some hp, but not a whole lot
@srtowner
4 жыл бұрын
Meth kits are not really about making more power. They are more about safely and reliably making power. It allows you to run more boost by increasing your fuel octane and running lower Intake air temps so it helps stop detonation and it helps keep your intake valves cleaner. In my opinion ALL turbo cars should have water meth injection.
@ProjectMini
4 жыл бұрын
💯
@boblabastida5171
4 жыл бұрын
@@srtowner That's what I thought. Added horsepower is by being able to add more boost because of higher octane and lower intake temp. I'm also adding the meth kit cause I understand it helps clean the intake valve stems and backside of the valves on a DI engine.
@ProjectMini
4 жыл бұрын
You don’t need to tune to get lower intake temps, lower intake temps will keep your ECU from pulling timing do to heat. Of course you will gain much more power if you tune for the methanol as stated in the video 👍
@cloroxbleach
4 жыл бұрын
why don’t you run a ram air intake to make use of the hoodscoop?
@ProjectMini
4 жыл бұрын
I will when i upgrade to the AEM intake
@Sulimankhayyat
Жыл бұрын
RPM say you have to have a built engine for stage 3. You didn't even mentioned that.
@AIRCOOLEDLIFE
13 күн бұрын
Hmmmmm, no you don't.....I have an RPM Stage 3 tune...my bottom end is factory on a Cooper S.
@Migotitadmiel
3 жыл бұрын
brother I have a 2012 cooper s R56, I can use the 380cc jcw injectors in this type of car, thanks
@markbedard6238
Жыл бұрын
What should the compression be
@bagofspanners72
4 жыл бұрын
What is a good reading for a compression test on the n14 engine
@ProjectMini
4 жыл бұрын
Around 150 psi, the reason i say “around” is because different compression testers will read differently. What is most important is that all four cylinders read within 5 or so percent. If you’re uncertain with the results of your compression test then do a leak down test
@samdarena6453
3 жыл бұрын
What exhaust setup are you running??
@ProjectMini
3 жыл бұрын
Mario Kart downpipe and Invidia Q300 exhaust
@samdarena6453
3 жыл бұрын
@@ProjectMini only the dp is needed to go stage 2 correct? Do I could go with the dp and the stock mcs exhaust?
@ProjectMini
3 жыл бұрын
Yes
@axxis001
4 жыл бұрын
What about the transmission? Can it handle so much power?
@ProjectMini
4 жыл бұрын
Yes, plenty of people are stage 3 with stock transmissions
@NatedoGP
2 жыл бұрын
@@ProjectMini are both manual and auto good to go?
@bijdikh8516
2 жыл бұрын
Unless you're running more than 270lb ft of torque, you should be fine with the stock clutch. Get an organic clutch and flywheel kit if you're going that high on torque, those can handle up to 350 lb ft of torque. The best part about organic clutch and flywheel kits, unlike stage 2 kits for example, is that they're still very light and quiet like a stock clutch. Seriously, don't waste your time with those garbage racing clutch kits, organic kits might be almost $2k, but they're worth the investment when you're going for high torque.
@khmerboogietonnaboy5757
4 жыл бұрын
Hey I think I follow you on ig 👍 I’m the one with bagged r56 . I’m from Cali
@ProjectMini
4 жыл бұрын
I follow a lot of people, my IG is @project_mini_official
@khmerboogietonnaboy5757
4 жыл бұрын
@@ProjectMini yes we are friends on there . Awesome video bro
@ProjectMini
4 жыл бұрын
Thank you 🙏
@cavellbrowne1158
4 жыл бұрын
Won’t u need to upgrade your Clutch???
@ProjectMini
4 жыл бұрын
It isn’t necessary for stage 3
@ismaelrojopereira2159
3 жыл бұрын
Hi! I am new r56 owner I want to scan ecu data with Torque and OBD, Some one can help me to understand what are the correct levels? Like intake air pressure , temperature Air intake and this things please? Pd. The car is n14 with dp,ic and repro Thanks
Пікірлер: 41