Some of the other videos showed, to vacuum out the dust after you drill
@stevem7250
4 ай бұрын
Yeah so if you resin the hole before inserting the bolt it will adhere to the edges not the dust. Stronger fixing.
@miked1913
7 жыл бұрын
Does this work for asphalt as well?
@JamesMontana
3 жыл бұрын
No this wont work on asphalt. You will need to dig a hole in the ground and repair the tarmac after.
@superbazooka213
3 жыл бұрын
I have a concrete drive and want a 4 ft walk through gate beside my house, 8ft double gate to the right of that and it will tie into my privacy fence. Will these support the 4 post needed for my gates? Or would I be better off renting a core drill and drilling the post holes in the concrete and then use a small auger bit to drill the ground to get proper depth and concrete the post in the ground like my others?
@JamesMontana
3 жыл бұрын
@@superbazooka213 i really wouldn't hang any size gate off these. Youre much better off drilling into the concrete and setting a post.
@superbazooka213
3 жыл бұрын
@@JamesMontana ok sounds good. Thank you! That is the direction I was leaning towards.
@FreightRunna8
22 күн бұрын
Looks like you’re having trouble 😂😂😂
@trenapickel6060
5 жыл бұрын
Do it yourself, go to stodoys and learn how to make it.
@becauseican151
3 жыл бұрын
Hi. Thanks for the video. Is there a way to use these on a slipping concrete drive? Thanks
@JamesMontana
3 жыл бұрын
I have made a video that goes into a little more detail on how this is done - kzitem.info/news/bejne/2XyhnaF8cZ-ajJw
@Andy2x4
3 жыл бұрын
Exactly what I was looking for! Thank you!!
@UkzEnglishBullTerrierz
3 жыл бұрын
How do you put gravel boards in with these ??? Lol ...
@fastflat4
3 жыл бұрын
Is a 4 inch slab thick enough?
@brandonjoseph1489
11 ай бұрын
Was it? We are putting a fence in 10 inch slab. The screws only go in 3 inches though
@qazinazifullah5851
Жыл бұрын
what kind of screws are good for concrete
@omarpena116
Жыл бұрын
Tapcon concrete screws from HD
@BushmanOutdoors
Жыл бұрын
I’m planning on installing a fence across a brick paved driveway. Could I use this method? Or is this solely for a concrete slab? Ideally don’t want to remove the paving and scribe around the post
@brandonjoseph1489
11 ай бұрын
I don’t think asphalt is the same strength as concrete to be honest the wind could rip them out. What did you end up doing ?😊
@pitbullslueth4358
2 жыл бұрын
I thought about this after the wind brought down my six foot fence and one of the concrete re enforced posts with it. Then I thought no, the wind will just rock it loose in no time and the rain will rot the fence post at the bottom, alright for small light fences I suppose....
@busty1372
Жыл бұрын
Design fence so wind will pass through
@brandonjoseph1489
11 ай бұрын
@@busty1372her we are building a 6 foot horizontal fence in a concrete slab 100 feet long. How big should we make the gaps. 1/4 inch okay? We want privacy
@brandonjoseph1489
11 ай бұрын
The wind toon down your post you put into the ground or concrete ?
@BigGinge167
6 ай бұрын
What size of tapcon screw is that?
@tonysmith550
Жыл бұрын
Don't you use wall plugs then ?
@maxneo11
Жыл бұрын
@RobertPriceBM
9 жыл бұрын
nunayafb - 6 foot is about the right height for a fence using this bolt-down method
@andrewayler
4 жыл бұрын
hey Rob, could you tell me where I could find those feet/bases. I'm not finding ones that tighten like the ones in this video.
@heroknaderi
3 жыл бұрын
I appreciate your time 😉
@osnapitsjoey
8 жыл бұрын
What if it's not a level piece of concrete?
@KarlH1980
7 жыл бұрын
Rough answer, make the base the opposite angle of the underlying concrete.
@whatyousaidbud
7 жыл бұрын
Joey Smith pack washers under the fixing holes on the low side so your screws/bolts clamp them as you tighten it down.
@covetedbeauty8084
7 жыл бұрын
What about concrete posts? Not wood
@tonyl1984
4 жыл бұрын
@@whatyousaidbud or use plastic c packer shims then the visible gap apply resin bond for a secure base
@SWEENEY561
4 жыл бұрын
can i dig out 4 inch holes in concrete driveway to install 4/4 inch fence posts . what equip. will i need
@JamesMontana
3 жыл бұрын
Yes of course you can. Its always stronger to concrete in a post. Just be aware of any services under the ground before you do.
@iamthebobs6996
4 жыл бұрын
Will this work for gate posts that will have a 4 foot wide and 6 foot tall cedar gate attached to it or should I break the concrete in the driveway in sink the 4x4 gate post down into the ground and concrete around it?
@JamesMontana
3 жыл бұрын
Definitely concrete it into the ground. Make sure to slightly mound the concrete around the bottom of the post to allow water run off.
@walternate2914
5 жыл бұрын
How do you make the post plum if the concrete slab has a grade to direct water away from the home?
@barryhenderson6375
4 жыл бұрын
Cut the end of the post at the same angle as the grade and put it in the post clamp and plumb it.
@JamesMontana
3 жыл бұрын
Use round washers under the bolt down plate to level it, before bolting it down.
@joelprice1
3 жыл бұрын
Did you ever figure this out? I have the same problem and my concrete slab slops down.
@brandonjoseph1489
11 ай бұрын
@@JamesMontanathis is what I was looking for. Washers yes! Thank you. I think they make a special thing for it do you know what it’s called it’s like a rubber mat
@marinawilliamson8723
5 ай бұрын
I saw it on another video. Shimmy is what he called it.
@dontwant1.43
7 жыл бұрын
how much spacing should you have between each one for a two ft fence please
@no_more_talk
5 ай бұрын
No more than 8ft. Unless you have them delivered to you
@jenniferbriggs4699
6 жыл бұрын
hi where did you get the bracket I checked amazon and nothing. Home Depot?
@FJUWANA
6 жыл бұрын
I just bought it at HomeDepot, but bit different style which also available at amazon a.co/b5E0lje
@ashleygaines6804
5 жыл бұрын
Lowes
@ashleygaines6804
5 жыл бұрын
Lowes has something similar
@ArrogantBaSStard
10 ай бұрын
Would this support concrete sheets with tile on one face, maybe with some horizontal posts for added stability?
@everythingsreal
7 жыл бұрын
No screw-plugs before putting screws into the concrete? really?
@justincourt668
6 жыл бұрын
Realistically if a professional shows go to your house to build a fence with these or any saddles send him home period. Your worried about screw plugs but these saddle won't last long I've been to many jobs where we had to dig up each sono tube and repour sono tubes with the fence posts inside. Regardless the height of the fence.
@thetruth9376
3 жыл бұрын
You can get self tapping fixings for concrete no plugs required
@alanrose7128
7 жыл бұрын
very nice
@samanthapiquette1449
5 жыл бұрын
How close to the corner/edge of the concrete can you drill?
@mica122213
5 жыл бұрын
not close
@JamesMontana
3 жыл бұрын
At least 2"
@atomicbrain9401
7 жыл бұрын
You can't do it. Boy, you can't do this.......ON CONCRETE.
@robd5326
6 жыл бұрын
why not?? He just did
@brandonjoseph1489
11 ай бұрын
Hey I’m about to do this on concrete with a fence. Why are you saying no?
@atomicbrain9401
11 ай бұрын
@@brandonjoseph1489 this is what happens when you try on concrete (video link) kzitem.infoX9m15uyVpIs
@AndrewHelgeCox
4 жыл бұрын
Is it more wobbly than going 60cm deep in concrete?
@conniemasters6318
9 жыл бұрын
Will this work with chain link fence posts?
@justincourt668
6 жыл бұрын
Connie Masters no.
@LordTylere
4 жыл бұрын
@@justincourt668 Why not
@duncanperrin2000
5 жыл бұрын
Why show general and not specific detail, like what you used to drill the bolts into/ what if concretes not level etc etc.... Don't bother unless you can unpick every part of the process.
Пікірлер: 71