Instead of installing an expensive car alarm system to prevent your car from getting stolen, why not install an inexpensive, hidden kill switch. This can be done with some basic tools.
The switch works by cutting the power to the fuel pump so you cannot jump start the car, hot wire it, or even push start it. We splice into the fuel pump relay and connect a hidden kill switch. Only you know where it is located, so only you can disarm it. When the switch is turned off the relay does not connect power to the fuel pump, so the car doesn’t start. When you flip the switch to the on position it allows the relay to send power to the fuel pump and the car starts like normal!
**If the video was helpful, remember to give it a "thumbs up" and consider subscribing. **
Disclaimer: Due to factors beyond the control of Pen-Pusher, I cannot guarantee against improper use or unauthorized modifications of this information. This video and all opinions are truthfully my own.
Pen-Pusher assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk.
Pen-Pusher recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of Pen-Pusher, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result.
Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Pen-Pusher.
Негізгі бет Автокөліктер мен көлік құралдары How to install a Hidden Kill Switch on your car
Пікірлер: 22