Nice installation. I wouldn't worry too much about not having gages newer reliable cars. But if you drive a 10 year plus old beater, chances are that original alternators could be at the end of their life cycle. It could provide you early warning before it leaves you stranded. Older high mileage vehicles require constant vigilance.
@AnthonyJ350
2 жыл бұрын
It's nice to have if you run a newer vehicle with aftermarket equipment. You can see what's happening to the system under load.
@victormanx
Ай бұрын
i dissgree, i just got stranded on a 20019 Yaris, no voltage gauge what so ever on the dashboard, basically the past days it started normally, it just showed some trouble starting todayy ONCE, and on the next stop i had to do on a store, nothing but clicks... a gauge would have shown me some lo voltage condition, and newer cars actually can start even if the battery is like 11V or probably lower, as i just took it off the charger after several hours, the battery shower 12.4V no load... and dropped to 10.8V and the engine still started once, but turning it off, then just clicks...
@TheRancher03
3 ай бұрын
You really need these on all vehicles to find out when your the alternator is going bad dropping to 12+ volts intermittently and not showing 13.x to 14.x volts at all times.
@AnthonyJ350
3 ай бұрын
Is handy. There are vehicles with regulated voltage control systems where it does fluctuate kzitem.info/news/bejne/mYSIx56mkop4lWksi=LOtAuSKR4-myecRP
@austindavis3557
9 ай бұрын
Great video! I’d definitely be interested in a short add on video explaining how to monitor voltage directly from the battery via relay. Thanks
@AnthonyJ350
9 ай бұрын
Will work on it!
@93coupes26
4 ай бұрын
Plz do!
@01wayne03
Жыл бұрын
I am interested in that video with the relay coming directly from the battery
@AnthonyJ350
Жыл бұрын
Thanks for the feedback!
@cm1133
Жыл бұрын
So am I.
@AnthonyJ350
Жыл бұрын
@@cm1133 Noted. Are you guys cool if I just do the video on the bench vs in a vehicle?
@jameswendellmiller
Жыл бұрын
I love the attention to detail. The shrink wrap over the loom is a great idea. As is the factory style connector. I really hate spade connectors.
@AnthonyJ350
Жыл бұрын
Glad you liked the setup 🙂
@lcsvlone2811
11 ай бұрын
Why do you hate spade connectors
@kaseyfrederick5531
Жыл бұрын
Did you ever make a video showing how to make the relay? I’m in the middle of my setup and am at a standstill trying to figure it out.
@AnthonyJ350
10 ай бұрын
Not yet
@ianpovey2577
9 ай бұрын
@AnthonyJ350 ,please make that video, thanks 👍
@brokenwrench404
8 ай бұрын
@@AnthonyJ350 any chance you’re working in the relay video?
@AnthonyJ350
8 ай бұрын
@@brokenwrench404 Not yet, I'll try to make one on the bench to demonstrate the concept
@user-yv8jq5ye9h
Жыл бұрын
Do you have the video on how to use a relay
@AnthonyJ350
Жыл бұрын
Yup, I have this video kzitem.info/news/bejne/2LB7t2qlnGiXdJg
@BoOmBaMan
2 жыл бұрын
That's a good option to have inside while starting any vehicle. I actually modified my schumacher battery tester to be able to plug into the cig lighter port instead of needing to pop the hood every time. I like how the loom was done on the harness. I never have the periphery proper sized heart shrink tubes. I just end up using electrical tape and zip ties (zaps)
@AnthonyJ350
2 жыл бұрын
Definitely. I was using 1/8th inch in the video. I can't even find it on Amazon, have to buy it from a local distributor.
@mikefabs5.0
Жыл бұрын
Great install vid. I am in between rewiring my boat, golf cart and classic car right now. I know alot about mechanics/fabrication just havn't dabbled with 12v electrical much. Great content.
@AnthonyJ350
Жыл бұрын
Glad it helped!
@s.porter8646
Жыл бұрын
Great tutorial, I recommend when soldiering close to electronics use a little alligator clip to be a heat sink to protect from cooking anything down stream, again really great vid. I had to add a volt meter to my 2017 Nissan Electric NV200
@AnthonyJ350
Жыл бұрын
That heat sink idea is a great tip! Thank you!
@alekmartin9999
5 ай бұрын
Is this better than available voltmeter in lighter socket?
@AnthonyJ350
5 ай бұрын
Might be
@tomcat5598
11 ай бұрын
Where did you get the plug connector from? Just on Amazon ? Thank you! Installing my volt meter and it’s running constantly now it’s time to watch your relay video and apply that 😂
@AnthonyJ350
11 ай бұрын
Yup, I find a lot of connectors on Amazon
@DGGuaglianone
Ай бұрын
Thanks
@AnthonyJ350
29 күн бұрын
You're welcome!
@bartman22x1
Ай бұрын
Is their a link to the gauge in this video ?
@AnthonyJ350
Ай бұрын
Check my Amazon store in the links on my channel.
@marcthompson1959
11 күн бұрын
I watched to get ideas on where to connect power and ground. Not much help. Loved the rest of it but still wondering
@AnthonyJ350
11 күн бұрын
But I showed you where I got the feed from.
@MK2GolfStories
Жыл бұрын
So what did you connect it to?
@AnthonyJ350
Жыл бұрын
Just wired it to the auxiliary power port.
@gloryghostrider_z3399
2 жыл бұрын
Thx!
@AnthonyJ350
2 жыл бұрын
You're welcome!
@virgilhopper5935
7 ай бұрын
Would a plug in volt meter have been just as good?
Пікірлер: 48