Nice, concise video. I find it interesting that you were able to shut and open the tailgate without issue. Just finished install on my 2022 F150 and the backend of the side rails don't clear the top of the tailgate. The only way I was able to get my tailgate shut was to shim between the top of the bed rails and the BAK side rails. Not exactly the best solution, but better than where I have read others "massaged" (i.e. bent upwards) the side rails to allow clearance of the tailgate. I would be interested in any similar situation you have found and/or solution.
@robertwood9628
2 жыл бұрын
Mine is ordered. This was the best example of how to install, thank you for the nice details.
@Realtruck
2 жыл бұрын
You are welcome!
@Marioform1
3 жыл бұрын
Looks like BAK learned from the shortcomings of the MX4. The old bloated hardware pack seemed like there had to be a better solution. One thing I am curious about is that there is no type of water drainage system on the Revolver, looks as though they're pretty confident in their mounting bracket by the bulkhead. I'd be interested to see what kind of waterproof seal can be maintained in the harsh winter weather that we have in NE Ohio!
@brianbolton8199
2 ай бұрын
After 2 1/2 years on my 2021 F150, the glue failed on the inside insulation, and the vinyl separated from the edges in hot weather. Beware of product failure and warranty.
@gromultimas2224
3 жыл бұрын
What could cause my tailgate to interfere with the left rail?
@donndavis142
2 жыл бұрын
Mines ordered. Waiting for the its been shipped email. My full bed rug is shipped. Get it on Monday November 15. Watcking this video closely to see if I can start to determine if a camper shell will go over.
@evilweener
3 ай бұрын
Probably going to get this one, but I figure you can’t drive with it rolled up , can you?
@jtthomas1
2 жыл бұрын
Wish mine was this easy... the side to side alignment isn't right. The tabs don't fit into the groove in the bed rails. Kind of frustrating, I guess I'll have to buy some shims.
@stanleynichols9990
9 ай бұрын
I just got a 2023. F150 and my buddy has one of tnever opened in the box but on the box it says 2 thousandand 15 to 2019 and like I said, I got a 23. Do you think it'll fit? Does anybody know?
@jameshale5684
6 ай бұрын
How do I get black clamps? They sent me bare aluminum clamps with x4s.
@sinajetta1746
6 ай бұрын
One of the star bolts doesnt even make it to the top of the tonneau cover by the bulk head... what should i do?
@josephkraft5640
2 жыл бұрын
This is the cover I want.
@DJ12Ema
2 жыл бұрын
Thanks for the video! It helps a lot… BE ADVISED!!!! PLASTIC PIECE AT THE CORNER CAN EASILY BREAK!!! Sadly it happened to me 😭
@jtthomas1
2 жыл бұрын
happened to me too, just now. did BAK send you a replacement?
@dannyarellano86
2 жыл бұрын
I seen another review video, guy installed and the first thing he did was take that plastic piece off and super glue it. It removed to easy guess yours was lost?
@94steadman
Жыл бұрын
My driver side piece popped out during installation 😅
@donndavis142
2 жыл бұрын
Step by step clearly presented.
@ROBERT-eg4ys
2 жыл бұрын
I have an 2019 f150 xlt sport crew cab 5.5ft bed. I don’t see this size on the website? Thank you
@Realtruck
2 жыл бұрын
Hey Robert, you can find it for your vehicle here, realtruck.com/p/bak-revolver-x4s-tonneau-cover/v/ford/f150/2019/?z=1641393213377. The bed size will be listed as 5.7 on our site. Hope that helps!
@AgustinLozada
2 жыл бұрын
There is another two-sided tape seal (red) and I did not find any instructions on where it should be applied. Is that for the edge of thetruck bed door?
@Realtruck
2 жыл бұрын
Hey there! That is a thinner bulkhead seal to use if you have a bed liner that wraps over the bulkhead. Hope that helps.
@hydro_rebel7741
2 жыл бұрын
Ordered mine from you guys for my RAM rebel a couple days ago, got an email estimate delivery next week sometime I absolutely cannot wait to get it. Just need the snow to go away and some warmer weather to install it.
@Realtruck
2 жыл бұрын
Feel free to share pics with us on Facebook or Instagram!
@TheCarCrazyGuy
3 жыл бұрын
I have the model that fits the 2015 through 2020 F150. I sold that truck and now have a 2021. Will the 2020 cover fit the 2021? What are the differences between the 2020 and 2021 model covers? They look the same to me.
@danenwoodward8112
Жыл бұрын
Just curious if you ever got a answer to this as I also have the same question
@TheCarCrazyGuy
Жыл бұрын
@@danenwoodward8112 supposedly the 21+ have different dimensions.
@SP-ql9mr
3 жыл бұрын
hi do a video on 2021 ford ranger bak x4s do not fit ??
@evanlong93
3 жыл бұрын
How much does the revolver weigh all in?
@donndavis142
2 жыл бұрын
My bedrug is in. I get my bak revolver x4s tomorrow.
@dannyarellano86
2 жыл бұрын
How's that combo
@begrateful8934
2 жыл бұрын
will this work still if I have a sprayed in bedliner?
Пікірлер: 33