Yes just two wires to snip everything else is ready to go. Thanks for watching. I hope you’ve subscribed. If not, please do. If not, that’s ok too. Have a great day!
@Twylightt
Ай бұрын
very good work, I have watched some videos. Is the best procedure for removing an entire pickguard, for the purpose of installing an EMG, to cut the wires at some point, or desolder? This is so that later I can exchange it again if I feel like it, or even sell it.
@WhiskeyxFuneral
3 ай бұрын
I'm getting ready to install the KH20 and have been trying to figure out if the battery would fit in the control cavity, this confirmed I'll be OK. Thanks so much for your video!
@stringmanguitars4329
3 ай бұрын
Absolutely! Thanks for watching!
@yobentley7274
Жыл бұрын
I had to plug the trem claw screw holes in a Strat wannabe once. They had stripped out. It was quite the process to handle the linear tension from the springs. I used end grain dowels and epoxy. Not to mention the drill alignment jig I created for the new pilot holes. I'll share the details of the jig if you want. I may make more and sell them. After the engineering, it worked great.
@stringmanguitars4329
Жыл бұрын
Yes Bentley! I’d be interested!
@yobentley7274
Жыл бұрын
@@stringmanguitars4329 I will assemble some pictures soon and email them to you.
@miespikpaou
Жыл бұрын
High! thank's a lot for your tutorial. I have a question...at 3'20" in your vidéo, you said that you snipped the ground wire...This EMG SL20 don't need this connection with the guitar? and another question...are they really noiseless, no buzz, no hummmmmm???? see you!
@stringmanguitars4329
Жыл бұрын
Thanks for watching. EMG says no ground needed. I've got a bunch of fluorescent lighting and I got no hum.
@digipeet2866
Жыл бұрын
hi...beautiful playing! i'm looking for a noisless set..what do you recommend at this moment..mojotone qiet 58...fender hot noiseless or this emg set?
@stringmanguitars4329
Жыл бұрын
I was never a big EMG fan until I installed these. These are outstanding.
Пікірлер: 11