So does this electronics and pickup change actually helped to get rid of the noise? Would be nice to hear it now. Just one little advice. Rather don't wangle/move connector on PCB from side to side. You can damage the connection on PCB board. Just pull it out straight, or when there's a clip hook, you push it first and then pull out.
@NimaPassionForMusic
Жыл бұрын
Yes, now it is noiseless and its different sound with EMG. Thanks for watching & your comment, and also your advice. Fortunately I didn't damage PCB
@NimaPassionForMusic
Жыл бұрын
I played the ending solo in this song with my Gibson Les Paul Tribute with EMG pickups (EMG 81) soundcloud.com/nima-ganjfar/the-last-time-i-cried-chris-de-burgh-cover
@cjurg2423
Жыл бұрын
Did your stock Gibson knobs fit on the new EMG pot shafts? Or did you have to order a different set of knobs? I plan on putting EMGs in my Les Paul and I can’t seem to find a video where anyone showed them using their pre-existing stock knobs. One video, the guy with the old white studio, said he had to use EMG knobs, but other than that, Idk..
@NimaPassionForMusic
Жыл бұрын
Very good question. No it didn't fit. And I'm still looking. Unfortunately it is too expensive to order directly from EMG, not the knobs but shipping . I contacted a local store and I hope we can find a solution for this problem.
@user-et8hh9hr2j
7 ай бұрын
🙏👏👏👏
@NimaPassionForMusic
7 ай бұрын
🙏❤🙏❤
@guistmagik2506
3 ай бұрын
EMG's are active pickups, but a les Paul doesn't have a battery, how to they become active without a battery?
@NimaPassionForMusic
3 ай бұрын
Did you see till the END? I mentioned the battery @14:11 and you can see the battery @14:19 on the right corner on the screen for just a second.
@limpjackass
4 ай бұрын
do u connect the 3 way switch that there is on the guitar somewhere and if yes where?
@NimaPassionForMusic
4 ай бұрын
I connected the 3 way switch to the "BUS" which I put in the middle of everything. There are 5 wires from 3 way switch. 3 of them is for pick up select which should wired to the green part of the BUS, and two others (one of them is earth) should connect to the black part of the BUS, which is beside the green one.
@limpjackass
4 ай бұрын
u had the original from the les paul or did you install the solderless emg 3 way switch@@NimaPassionForMusic
@limpjackass
4 ай бұрын
can u do a tutorial if its possible @@NimaPassionForMusic
@limpjackass
4 ай бұрын
so you just connect the 3 way switch to the bus no where else? also did you connect it with solder or the cables that come with the pickups @@NimaPassionForMusic
@NimaPassionForMusic
4 ай бұрын
@@limpjackass I used the Original from Les Paul. There was not any 3way switch in the package I received from EMG . Watch this : kzitem.info/news/bejne/u5ytvHmVqJqopno
Пікірлер: 24