Hi I’ve been watching a lot of your videos trying to diagnose my 04 ego txt. It’s not going in forward or reverse. I started with the battery’s 6.3 on each then checked under power all added up to 36 volt. Moved to the controller when gas is pressed solenoid pulls in can hear it. Just bought the cart and the controller looks brand new I’ve rode it maybe 3 times. Anyways checked the solenoid and voltage running through also under power that’s good. Checked up at the controller voltage was good. Checked the IWS I believe it’s called? White wire it’s good as well slowly increases under load. After all that thought maybe motor was burned up. Pulled the wires off jumped the terminals and used a 12v battery motor spins great. So only thing I can think of is forward and reverse switch but not sure how to test it. If you could give some feedback love the videos!
@HeyHeyHey97
2 ай бұрын
Did you check voltage going out the controller. Red lead on a main positive and black lead on the m- post on controller. It’s the big post that’s closest to the battery. And tell me what you get.
@tallentedward21
2 ай бұрын
Now the solenoid won’t click only .6 coming out the controller but earlier I had around 36
@tallentedward21
2 ай бұрын
@@HeyHeyHey97showing 37 going from solenoid to controller but controller is not pulling in under load now
@HeyHeyHey97
2 ай бұрын
If all other voltages check like they should and there’s no voltage coming out the controller. Then that means the controller is bad.
@tallentedward21
2 ай бұрын
@@HeyHeyHey97 I’m not sure I seen your number are you close to NC? Do you have a shop I could bring it to you?
@abnerschmucker1
2 ай бұрын
Hey Thomas. Explain how Trojan batteries are better than Continental's or Costco.
@HeyHeyHey97
2 ай бұрын
Higher amp rating. On a discharge machines they run more minutes than any battery I’ve seen. And they always last longer as far as years.
@bbrcummins1984
2 ай бұрын
Good afternoon, I've got 04 EZ go gas power , I've picked up a whining noise, either belt or maybe bearing, any suggestions ? Thank you
@HeyHeyHey97
2 ай бұрын
Bb what’s up man. Does it do it in forward and reverse. Or just in one direction. If it is gears it will do it in forward and then do it in reverse when you let go of the gas. Or vice versa also timing belt noise is coming.
@bbrcummins1984
2 ай бұрын
@HeyHeyHey97 Thanks for the reply, I'll pay close attention to that tomorrow and I'll let you know. Thank you ✌️
@bbrcummins1984
2 ай бұрын
@HeyHeyHey97 Good morning. It does it forward, reverse and natural, Timing belt ??
@HeyHeyHey97
2 ай бұрын
@@bbrcummins1984 yeah either timing belt or starter bearing. Take the drive belt off the rear clutch. And that way you can eliminate the input shaft bearing in the rear end whining if you don’t know how to get it off let me know I have a video on how to remove belt.
@bbrcummins1984
2 ай бұрын
@HeyHeyHey97 Thank you sir , 👍✌️✌️, I've watched your video on removing belt .
Пікірлер: 18