you are my hero .. an old carjack puller . and copper grease .. sheer brilliance .. a seal quality mechanic .
@billjackson6501
5 жыл бұрын
Good job.Innovation and helped me sort the same job.Well done
@darkwaterblue
2 жыл бұрын
Hole saw a old car jack and some graft. Great video!
@stefangavrilovic8355
5 жыл бұрын
This is real DIY with no fancy tools video 😂
@mrwmaad
5 жыл бұрын
good work
@Steve-xb7dn
Жыл бұрын
Put it in the freezer overnight before you do it and it will be a hairs width smaller and fit in easier
@williambruning4769
Жыл бұрын
Could use blowtorch to heat up and loosen it?
@kostasrestas
3 жыл бұрын
hallo there! can i raise my peugeot 307 sw 2007 diesel some cantimeters with longer springs?? or can i put some spacers at suspension rear and front?? i want moore ground clearence...
@terryjones2012
Жыл бұрын
easier to drill out the rubber and then remove the outer sleeve
@dracony7649
2 жыл бұрын
What symptoms did u have when these brushes usualy fail ?
@mkdalraisi307
2 жыл бұрын
Clanking noise, knocks
@johnmayberry7669
4 жыл бұрын
Done loads of these. with these basic tools he must have been at this for hours 😂😂😂😂😂
Пікірлер: 15