Nice thorough video. A friend of mine who knows everything about everything recommended these anchors. I have to anchor a gazebo to a concrete pad. This video explains how to do the holes perfectly.
@KooperSalmo
3 жыл бұрын
Make sure to clean out all the concrete dust from the hole, bore out your hole a half inch from the top more then the main hole so the wedge goes in deep and doesn’t get stuck, place the washer and nut on before you really hit it hard with the hammer or else the nut won’t screw on the threads and ratchet the nut tight and cut it off to make it look pretty.you must use a hammer drill or a drill with the hammer setting to drill into cement.
@roberttate2009
2 ай бұрын
The ring doesn't go down. The flared part is pulled up on the ring.
@Eger118877
2 жыл бұрын
Great Video! I always try to have a small shop vacuum handy when I have to drill masonry. I think it prevents a lot of that unhealthy dust from going everywhere. I understand there are times when you won't be able to have a vac with you.
@Radar120155
Жыл бұрын
Probably just as healthy unless your Vac is HEPA filtered.
@paulosbornept7523
Жыл бұрын
Well done, thank you for the info. This should save me some headaches.
@Leo.DegariOrtiz
Жыл бұрын
Very good Vato,,excelente.👌
@kennycetera1522
3 ай бұрын
Would love it if you mentioned how deep you were drilling for that particular wedge
@KooperSalmo
3 ай бұрын
Well deeper then the screw length
@JimOrr_OK
2 жыл бұрын
Good instructional video. Thank you.
@terekn2915
3 жыл бұрын
Nice set of instructions. Thanks
@ProfessorBeautiful
10 ай бұрын
I learned a lot. Thanks.
@mikef.6216
Жыл бұрын
Why not use a shop vac instead of a blower?
@Radar120155
Жыл бұрын
Probably just as healthy unless your Vac is HEPA filtered.
@roberthenry9319
9 ай бұрын
Marvelous. Thank you.
@ethanramsey5560
10 ай бұрын
Great video!
@Not_today_713
Жыл бұрын
9:46 He starts twerking
@KooperSalmo
3 жыл бұрын
Make sure to clean out all the concrete dust from the hole, bore out your hole a half inch from the top more then the main hole so the wedge goes in deep and doesn’t get stuck, place the washer and nut on before you really hit it hard with the hammer or else the nut won’t screw on the threads and ratchet the nut tight and cut it off to make it look pretty.you must use a hammer drill or a drill with the hammer setting to drill into cement.
Пікірлер: 18