Never use gauging blocks like he said in vid battens differ in size u need to gauge it out and ping lines plus u av to change gauge about to work into apex of roof
@a.m.d493
9 ай бұрын
Great, detailed tutorial...lots of tips...
@christiandixon2086
14 күн бұрын
Good way to get waves in the battens, doing it like this your taking a measurement from top to bottom, should measure top to top of the batten. Especially for the fact you're using 2 different suppliers
@anthonyashton4524
9 ай бұрын
always batten plain tiles up in 8s to the top, then fill inbetween downawards, much faster. also allows for proper gauging
@mos6507
Жыл бұрын
Geico gecko is now a roofer, apparently.
@stena_vlogs
Жыл бұрын
What is the gap between the battens from inside of batten measurement?
@CrustyAbsconder
2 жыл бұрын
I have a question for your viewers. I really wanted to watch your presentation. But I got motion-sickness in less than 10 seconds. Do other people have this problem ? And what is the solution ?
@redsresearch
4 ай бұрын
those battens are gunna rot out
@garymatthews646
Жыл бұрын
wrong= you always line for the battons
@serbancatalin1875
10 ай бұрын
To many cuts in rows Should be 200 mm 3 minimum cuts
@tsunamitube3351
Жыл бұрын
Your gauge is bad. It does not allow for difference in battens. Make a proper dolly or use a tape. I only give dolly's to newbies
Пікірлер: 11