what size bars (height) and did you have to extend wiring or get longer cables?
@christophermarshall2406
10 ай бұрын
You left out the most important part of the install. Where you actually install the bars. How did you mount them?
@sethg8501
7 ай бұрын
Does the two pin connector attached to the 6 pin on the TBW plug into anything? I am doing mine now and can not remember, also can't find a female 2 pin connector.
@Thebigmilkfish
3 жыл бұрын
Those are the junk bushings that gave a 2” back and forth play on my RG. Great information. Replaced and no mo I play
@STAYHUMBLE302
3 жыл бұрын
Good stuff brotha keep them coming 🔥👊
@brianfosterjr.2469
2 жыл бұрын
What year is that Road Glide
@GLockunoporciento
3 жыл бұрын
Eyo Brother, I’m going thru this dilemma right now. Outstanding video my brother. Mongol on. Huah!! Grimlock 1%er Mongols MC Washington
@tealbagger
3 жыл бұрын
HOLY SHIT OF ALLLLL PEOPLE to randomly see in a comment. Glad to see youre still kicking and ripping. Hope youre doing well old friend. - Kaelin(CDC)
@ericjames7680
3 жыл бұрын
On a 2020 or so RoadGlide, can you see the gauges good enough? Was looking at KRAUS, but this video got me to thinking maybe an install like this using Lucky Dave's MX/ TBAR?
@SC-br6tu
3 жыл бұрын
Hey man could you do a video about the M8 as far as top end noise? What’s normal and when you should be concerned?
@JWG1988
2 жыл бұрын
I installed a set of chubby 13” on my 2010 Rg - fucking amazing handling!
@remilavallee5872
Жыл бұрын
Did you need cable extensions?
@ryansimms8264
3 жыл бұрын
What brand bars are those? They look pretty rad.
@samandrews1395
2 жыл бұрын
Do you know the part number on them bars All the width in between
@scottmaclean9607
3 жыл бұрын
Nice video bro
@haydenremnant2651
3 жыл бұрын
Great stuff!
@jessicadunn1806
3 жыл бұрын
Where did u get your t bar from?
@RickyHD
3 жыл бұрын
Dominator cycles
@toolbrothers1477
3 жыл бұрын
I noticed you didn’t internally wire those bad boys
@RickyHD
3 жыл бұрын
No they came with an internal wire hole at the bottom but was too small for the overall diameter of the ultra wiring content and i didn’t want to damage the structural integrity of the piece by boring out. So i dremel the center bar and ran the wires through the center.
Пікірлер: 25